Mustang Mt82

There is a TSB for using a different fluid in colder weather.

I installed a Steeda Shifter Bushing, ditching the stock foam one, and have noticed a significant improvment.

I've experienced the shifting problem only during the cold months. Which in Louisiana and Texas isn't very long and once the fluids warm up there's no longer any problems. The shifting is 100x better too after I installed a MGW shifter and from what I've read in other forums some guys have even better shifting with stiffer engine mounts. Since the shifter is a remote system it twists with the car, not the engine. From what I have read the transmission doesn't do well if you're doing a lot of pulls with a 600+ RWHP car. I should've said more when I first posted, but I was tired. If you want a better transmission with no worries then you'd do the tranny swap with the better Tremec T56 Magnum, but it'll cost ya.

Well people complain about the T-5 and the T-3650 too so it's not like it's a new thing...

I only hate my 3650 on days that end with y. Other than those days, it's great.

Sent from my EVO using Tapatalk 4

jetmech807 said:

I only hate my 3650 on days that end with y. Other than those days, it's great.

Sent from my EVO using Tapatalk 4

Click to expand...

Hey Hey! Get back down there to the SN-95 thread!

My 2014 gt with track pack seems fine. For me it took a little practice getting used to the close gates. I have no shifting issues so with 6500 miles. The skip shift has been eliminated by ford. Not sure of any other changes. I do have a slight gear whine at lower Rpm's. But no big deal. The shifting seems to be getting smoother the more miles I drive. It goes in storage soon so I cant comment on cold weather. In the mid 50's , in the morning. So far so good. ( Im all stock )

TheRican said:

Are these transmissions trash like I keep hearing?

If so, avoiding this generation of Mustang. Every build that I see going on on other forums are replacing this transmission for a Tremec

Click to expand...

Swap the short throw and bracket- but if you're like me and are into forced induction kits - you'll want a Tremec. I'm sitting around 580hp at the moment. However, I'm afraid to launch hard because I'll probably cut its life in half. I hear it can last up to 590ft lbs, so I should be okay. Shame on Ford...