Did a search but did not get quite the answer I was looking for. Ok I have just come a cross a old style Edelbroke Performer 5.0 intake manifold for $200.00. SO I bought it and I am deciding whether to install it on my mostly stock 1993 105K mile 5.0 Mustang, or hold off and use it on my new 331 stroker motor I am presently building in my garage on an engine stand.
Questions
1. How much horsepower if any will I pickup with just bolting on the Performer intake. My mods are listed below...
2. Will it improve my 1/4 mile time or just bog me down...
3. Is $200 a fair price for this manifold...
4. Does any board member run a simuler setup if so what are your first hand experiences...
5. Is it difficult to install.
6. Should I also install new fuel rails, Fuel Pressure Regulator, and new 24 pound injectors...
Thanks all!!!
Questions
1. How much horsepower if any will I pickup with just bolting on the Performer intake. My mods are listed below...
2. Will it improve my 1/4 mile time or just bog me down...
3. Is $200 a fair price for this manifold...
4. Does any board member run a simuler setup if so what are your first hand experiences...
5. Is it difficult to install.
6. Should I also install new fuel rails, Fuel Pressure Regulator, and new 24 pound injectors...
Thanks all!!!