Need some quick sizes of bolts: Transmission bellhousing, pressure plate, flywheel..

[5spd GT]

What size are the bellhousing bolts for a 87-95 bellhousing?

Pressure plate bolt size? 7/16"?

Flywheel bolt size?

I'm just trying to put something together and it has been a while...

Drain plug is 3/8" right?

What is the 02 sensor size on the bungs? Is it 7/8" or something along those lines?

 

[Mustang78]

flywheel bolts might be metric, and my bellhousing bolts are 7/16"..thats all i can remember

~Mark~

 

[5spd GT]

bump...

I know the bellhousing bolts are bigger than the two bottom bolts that help hold on the plate between the bellhousing and block....

Are the flywheel bolts 18mm?

 

[C6AE]

the two bottom bolts that help hold on the plate between the bellhousing and block

I need a couple of those if anybody knows the size

 

[5spd GT]

Does nobody know, basically I just need to know the socket size to use on them, that is all:

 

[TheUser]

Are you in a position where you can just use trial and error to find the correct size? That's usually how people do it if they can't eyeball it.

Not to be an ass, but seriously...

 

[5spd GT]

I don't have the car right now. It is getting the air conditioner fixed...

Also, I never know on my tranny (since it has been swapped from an AOD to a t5) has stock size bolts.

 

[tylerrocks]

Does nobody know, basically I just need to know the socket size to use on them, that is all:

Just put a new G-force in my car last night.

Bellhousing- 5/8 (head)
Tranny-5/8 (head)
pressure plate- 5/16 thread 3/8 head (undersized head)
Didn't actually check the flywheel bolts but IIRC they are 3/4 (head)

I'm going back out to the shop right now so I'll check and make sure I told you correctly.