Needing opinions

[homebulit gt]

I am new here and am wanting other people's opinions on which way I should make my 4.6 2v engine run. I am debating between EFI and carburetor. I am at a predicament cause I have the engine with no intake and I have the engine wiring harness but no pcm for it so can people give their opinion

 

[McFly2]

Find an engine installer close to you that might help you out.

Find An Installer | www.jasperengines.com

Need a reliable engine or transmission installer? Look no further than JASPER Engines & Transmissions. Find trusted installers near you for 'automotive shops near me'.

www.jasperengines.com

 

[homebulit gt]

The thing is the motor is going in a way older car than it besides you have any opinions on the msd 6 ignition controller I seen it and thought it might work

 

[MarvinN888]

Hello, I have an MSD 6A, it used to be on the my father's 240 wagon from auction streaming, now it's on the '63 PV. In both cases, I left everything else on the car's ignition system alone, I just pulled the wires off the coil and hooked those to the MSD input. Then hooked the MSD output to the coil, and wired up the power supply to the MSD.
This leaves everything else regarding the ignition in place and operating normally. If the MSD box dies (My Spark Disappeared!) you can swap back to normal coil wiring very quickly - just unplug the MSD input wires and hook them back directly to the coil.