I just tries to install an Avery Nano Fusion bra on my 2012 Mustang. Watch several videos from the sellers web site, and Avery Dennison's site, and I was quite certain I could do it. First thing, it didn't matter how much slip solution I sprayed, it kept sticking to my paint. Had to peal it back numerous time to get everything alligned correctly (1/8" all around), tacked the ends, started from the middle, and had two spots where it was impossible to get it to lay right, without a giant finger which would only crease. No way was that going to work, and at this point it was a waste. Don't know if it was cut wrong by the seller, but I had to remove it, and that was $125 down the drain. D.I.Y. BEWARE!