• Mustang Forums
  • 1965 - 1973 Classic Mustangs -General/Talk-
  • Classic Mustang Specific Tech

Starter Solenoid

  • Thread starter Thread starter suki243
  • Start date Start date Aug 20, 2007
S

suki243

Member
Dec 19, 2006
662
0
19
Southern California
Aug 20, 2007
#1
  • Aug 20, 2007
  • #1
I think I'm just having a bad week or something... Previously, after replacing some of my alternator to voltage regulator wiring, i wasn't able to get my car to start... Then with the help of the forum and wiring diagrams i was able to start it up and it ran perfect for a day or two.
Then... today I started her up, once, it was fine except it turned over a little slow, but I was checking the voltages around the car, so then i turned it off. Then a few minutes later I tried turning it on and it'd turn over and then stop and then turn over again, but i think i held the key in the crank position for too long, i then gave up and decided the battery is probably dead or low...
However, I looked at the starter solenoid and it was glowing on the side that leads to the starter motor! i quickly disconnect the battery but it is still smoking on that side... I then try a new battery later on in the day and now i only get one loud click...

I'm pretty sure that the solenoid is shot i'd just like to confirm it with you guys and find out what i did wrong so i don't do it again. Did i leave it in the crank position for too long?
 

enferno

Member
Jun 20, 2006
418
2
16
Aug 21, 2007
#2
  • Aug 21, 2007
  • #2
sounds like you fried your solenoid. i was always taught never engage a starter for longer than about 8 seconds without a break. a lot of power flows through there when you are engaging your starter.
 

scrutmonkey

Member
Jan 17, 2003
243
0
16
San Jose, CA
Aug 21, 2007
#3
  • Aug 21, 2007
  • #3
wow, got a pic of it glowing? new starter noid and you should be set.
 
S

suki243

Member
Dec 19, 2006
662
0
19
Southern California
Aug 21, 2007
#4
  • Aug 21, 2007
  • #4
haha I shoulda taken one huh, no i was scared it was gonna catch on fire i was lookn for a fire extinguisher just in case... I'm really gonna get one now... Luckily it wasn't too expensive of a lesson
 

HookandLadder

Founding Member
Feb 17, 2001
261
0
17
St Louis
Aug 21, 2007
#5
  • Aug 21, 2007
  • #5
Make sure you check the wire from the solenoid to the starter. They don't glow for nothing usually.
 
You must log in or register to reply here.

Similar threads

M
85 mustang 5.0 cranking in run position
  • Mamaclean
  • May 23, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
3
Views
169
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 1, 2026
General karthief
3
Electrical Starter solenoid out of space?
  • 387lx
  • Jan 22, 2026
  • Fox 5.0 Mustang Tech
Replies
3
Views
412
Fox 5.0 Mustang Tech Jan 23, 2026
387lx
3
3
Electrical Starter solenoid green wire?
  • 387lx
  • Jun 1, 2026
  • Fox 5.0 Mustang Tech
Replies
3
Views
189
Fox 5.0 Mustang Tech Jun 2, 2026
AeroCoupe
E
2007 GT Stalls when lights or a/c turned on
  • ejscarfo
  • Jun 22, 2026
  • 2005 - 2009 Specific Tech
Replies
2
Views
206
2005 - 2009 Specific Tech Jun 29, 2026
ejscarfo
E
M
2004 v8 convertible
  • Mikeycrownvicluver
  • Feb 12, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
11
Views
427
1996 - 2004 SN95 Mustang -General/Talk- Feb 15, 2026
Mikeycrownvicluver
M
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1965 - 1973 Classic Mustangs -General/Talk-
  • Classic Mustang Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?