I was wondering I took apart last year was wondering if any one out there had a pic of how the steering goes back like the tie rods and the center link and also pic of the front fender wondering if I installed the fender aprons on rite
Here is a couple of pics of a manual steer set up ,and the front fender aprons .
The longer rod ends go to the inside ,the shorter to the out side . Some pics of your aprons will help.
Are you doing the whole front clip or just the aprons? You will need measurements for the radiator support to the cowl for the fenders to line up correct . This is a 68 but it is the same as a 67.I haven't sand blasted this compartment yet so it looks pretty rough.
From the outer front edge of the cowl to the front of the radiator support is
44 1/2 inches. It will be the same on both sides.
I will have to measure mine it looks like mine might be kick out just a little bit where the hood hinges go.yea im replacing the whole front end of the car also