The door handle bezels have been replaced. New speakers in all 6 spots. I went ahead and replaced all the wiring while the interior was out. New center arm rest pad. I took that entire thing apart to cleans and spray it. It was not easy to put back together. The hatch supports are new. I replaced the hatch weather stripping. Also bought front seat belt sleeves. I haven't installed them yet. I think that's about it for the interior. I'm sure there is more but I can't think of them.
Under the hood I got the 6AL sorted out and it has been mounted on the inner finder well by the intake. You can see it in other pics I've posted. Replaced all the hoses, water.and power steering. New radiator bushings. Rebuilt the power steering pump. New alternator
New water pump. Just picked up a factory crank pully from a local shop. My alternator had melted the plug and was burnt looking. New SN95 rack and pinion. I also picked up a MM steering shaft.
SVE bump steer kit. The car is lowered.
The last time I drove the car it was awful. Keep in mind this was before replacing or upgrading anything on the
suspension or steering. I have yet to get all this stuff removed and replaced..That was also the first long drive I had taken in it. About 100 miles or so. It just kinda mushed around in the corners. Steering was sloppy. It just wasn't right. That's when I decided to go through the steering and
suspension from front to back. I might regret it but I went with the energy
suspension polyurethane kit. I also put offset rack bushings on it. I plan on upgrading to coil overs in the future so I went with an OE front strut. I bought Moog ball joints. I have all the bearings for the front spindles. I went ahead and bought new rotors and pads. When I took the water pump off and replaced it with a new one the timing chain cover started leaking. With everything else off I ended up dropping the k member and replacing the oil pan gasket, timing chain cover gasket, and front main. Last night i got the k member up, rack reinstalled, drivers side spring installed, spindle on, and sway bar end link on. Hopefully tonight I can get the strut installed.