• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

Tranny problem 2000 gt

  • Thread starter Thread starter rb20100
  • Start date Start date Feb 13, 2006
R

rb20100

New Member
Feb 13, 2006
6
0
0
Feb 13, 2006
#1
  • Feb 13, 2006
  • #1
i have a 2000 gt and have been having some problems with the tranny. When i shift into 3rd u can just pull it right back out without having to press the clutch, same for 4th gear.....but all the other gears are fine......also the tranny grinds about 80% of the time while shifting into 5th gear
Anyone have any advice?


Also sometims when i get on the throttle the battery light blinks on, but it turns off, but it think i need a new battery because it is getting pretty hard to start.....but, i don't think the light should blink on if i am on the trottle all the way,or should it?
 

Mike97gt

it doe snot
Founding Member
Jan 26, 1999
10,633
7
89
the people's republic of massachusetts
Feb 13, 2006
#2
  • Feb 13, 2006
  • #2
ok first the battery light. a lot of times when the battery light flickers when you are at WOT or more than 1/3 down on the gas that means the belt is sliping. check your belt tensioner and belt. it's probaly seized.

ok now the trans concern.does it slip back out of 3rd on it's own? and do you have a aftermarket shifter installed?
 
M

Mindstatic Pro

New Member
Jan 15, 2006
107
0
0
INDY
Feb 14, 2006
#3
  • Feb 14, 2006
  • #3
Also, are you pulling it out of gear under throttle or w/ your foot off the gas?
 
R

rb20100

New Member
Feb 13, 2006
6
0
0
Feb 15, 2006
#4
  • Feb 15, 2006
  • #4
svttech76 said:
ok first the battery light. a lot of times when the battery light flickers when you are at WOT or more than 1/3 down on the gas that means the belt is sliping. check your belt tensioner and belt. it's probaly seized.

ok now the trans concern.does it slip back out of 3rd on it's own? and do you have a aftermarket shifter installed?
Click to expand...
for the tranny it sometimes slips out of gear yes, yes i have an aftermarket shifter, but it did it more when i had a stock shifter. Or sometimes i could press the clutch down then slowly let it out and it will slip out of third even if i am pressing on the gas..
 
R

rb20100

New Member
Feb 13, 2006
6
0
0
Feb 15, 2006
#5
  • Feb 15, 2006
  • #5
Mindstatic Pro said:
Also, are you pulling it out of gear under throttle or w/ your foot off the gas?
Click to expand...
u are able to pull it out of gear with your foot on the gas and when your foot is off the gas without touching the clucth
 

Mustang5L5

That is…until I whipped out my Bissell
Mod Dude
Feb 18, 2001
43,371
18,119
224
Massachusetts
Feb 15, 2006
#6
  • Feb 15, 2006
  • #6
rb20100 said:
u are able to pull it out of gear with your foot on the gas and when your foot is off the gas without touching the clucth
Click to expand...

That is actually normal.....to a point.

The way the dog teeth on the tranny are designed, they interlock when the trans is under load. That means if you were in 1st and were on the throttle moderately or WOT, you should not be able to pull the shifter out of 1st. When the load is off, you can easily glide it out of gear.

One drag racing tip is to go WOT in a gear while pulling or pushing the handle slightly towards the next gear. When you kick in the clutch, it will allow you to shift as soon as the load comes off the gear. The teeth on the gear will prevent you from pulling out of gear at WOT...when they work properly of course

If you can pull it out of gear with a little pressure when you are on the gas a good amount, then the dog teeth are wearing down and you may need to have them replaced.
 
R

rb20100

New Member
Feb 13, 2006
6
0
0
Feb 15, 2006
#7
  • Feb 15, 2006
  • #7
thanks for the advice...especially about the drag tip.......
 

Mustang5L5

That is…until I whipped out my Bissell
Mod Dude
Feb 18, 2001
43,371
18,119
224
Massachusetts
Feb 15, 2006
#8
  • Feb 15, 2006
  • #8
Just don't a lot of force into it. You only want a slight preload.
 
You must log in or register to reply here.

Similar threads

G
2000 GT- Alternator not charging
  • grugug
  • Tuesday at 8:30 PM
  • SN95 4.6L Mustang Tech
Replies
10
Views
68
SN95 4.6L Mustang Tech Thursday at 9:04 AM
squeak93
00 4.6L V8 new clutch won’t go into gear when on?
  • Timboslice
  • Aug 15, 2026
  • The Welcome Wagon
Replies
3
Views
228
The Welcome Wagon Aug 21, 2026
Noobz347
K
Electrical 2000 GT Intermittent Engine Shutdown In Motion - DTC U1262
  • kenster1092
  • Apr 13, 2026
  • SN95 4.6L Mustang Tech
Replies
4
Views
347
SN95 4.6L Mustang Tech Apr 24, 2026
squeak93
K
4r70w transmission problems
  • Kiddmustang
  • Jul 14, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
5
Views
216
1996 - 2004 SN95 Mustang -General/Talk- Jul 21, 2026
squeak93
W
Speedometer and shifting issues
  • wyatt-tetro891
  • Aug 17, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
6
Views
290
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Aug 18, 2026
wyatt-tetro891
W
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?