• Mustang Forums
  • 1965 - 1973 Classic Mustangs -General/Talk-
  • Classic Mustang Specific Tech

Transmission Fluid Leak - Question

  • Thread starter Thread starter Smash It Up
  • Start date Start date Nov 25, 2007
S

Smash It Up

New Member
Oct 26, 2007
33
0
0
Las Vegas,nv
Nov 25, 2007
#1
  • Nov 25, 2007
  • #1
I have a slight leak coming from the point where the drive shaft joins the tranny.


You can see that it is only a slight drip,but what I want to know is,is there something simple like a seal in there that needs to be changed,or is it something more ?

thanks
 

Attachments

  • mustangunderside018zu9.th.webp
    12.6 KB · Views: 197

68Rustangs

New Member
Oct 5, 2007
39
0
0
Sun Prarie WI
Nov 25, 2007
#2
  • Nov 25, 2007
  • #2
More than likely just a seal. What kind of transmission is it?
 
S

Smash It Up

New Member
Oct 26, 2007
33
0
0
Las Vegas,nv
Nov 25, 2007
#3
  • Nov 25, 2007
  • #3
Oh yeah,sorry,its an FMX
 
S

Smash It Up

New Member
Oct 26, 2007
33
0
0
Las Vegas,nv
Nov 25, 2007
#4
  • Nov 25, 2007
  • #4
FMX problem

When I start my car,lately i have noticed that when i put the tranny in drive (or any gear),it acts like it is still in neutral,until after about 30 seconds or so,then it will. Once it gets going ,it's fine,just get the prob right after i start it up. Any ideas?
I thought maybe since i had a small leak at the tailhousing end,it may have leaked out enough tx fluid over time to affect it,but i checked the level and it is within tolerance according to the dipstick.
 

68Rustangs

New Member
Oct 5, 2007
39
0
0
Sun Prarie WI
Nov 25, 2007
#5
  • Nov 25, 2007
  • #5
Mabye the following site will help you out. It has some exploded views of the internals. It may help you narrow down what the problem might be. It could be the oil seal after the sun gear or something after that.


http://www.charlietranny.com/FMX.htm
 

68Rustangs

New Member
Oct 5, 2007
39
0
0
Sun Prarie WI
Nov 25, 2007
#6
  • Nov 25, 2007
  • #6
Smash It Up said:
When I start my car,lately i have noticed that when i put the tranny in drive (or any gear),it acts like it is still in neutral,until after about 30 seconds or so,then it will. Once it gets going ,it's fine,just get the prob right after i start it up. Any ideas?
I thought maybe since i had a small leak at the tailhousing end,it may have leaked out enough tx fluid over time to affect it,but i checked the level and it is within tolerance according to the dipstick.
Click to expand...

Its a hydraulic transmission so it sounds like you may have a bigger problem around the corner than that little leak. I would take the leak and the not going into gear right away as some good warning signs you need to do some repairs. If your are not able to rebuild/repair it yourself you may want to have a good shop check it out. You may not get a third warning sign. Im no tranny expert but those are my thoughts.
 
S

Smash It Up

New Member
Oct 26, 2007
33
0
0
Las Vegas,nv
Nov 26, 2007
#7
  • Nov 26, 2007
  • #7
Yeah I was planning on having the whole drivetrain checked out anyway soon so hopefully i'll find out before anything major happens !
 
6

66forfun

Member
Feb 25, 2006
260
0
16
Pittsburgh
Nov 26, 2007
#8
  • Nov 26, 2007
  • #8
probably the rear seal. watch for excessive wear on the yolk. the hesitation could be bad u-joints.
 
S

Smash It Up

New Member
Oct 26, 2007
33
0
0
Las Vegas,nv
Nov 26, 2007
#9
  • Nov 26, 2007
  • #9
66forfun said:
probably the rear seal. watch for excessive wear on the yolk. the hesitation could be bad u-joints.
Click to expand...

that might explain it. I don't understand though why it only does it when I have just started the car,but once I get it in gear and get driving,it seems fine,although it does slip a couple times for the first couple hundred yards.
I'll definitely make a point of that to the person I get to look at it.

As for the yoke,would it wiggle if it is worn,I mean,could it be wiggled by hand to tell if it is worn? (As opposed to being a tight fit if normal)
 

Rusty67

20+ Year Stangneter
Dec 3, 2002
3,749
37
109
LA, CA
Nov 26, 2007
#10
  • Nov 26, 2007
  • #10
There shouldn't be any play between the output shaft of the trans and the yolk. You may warn u-joints as mentioned earlier. Be careful not to let these fool you into thinking your yolk is bad.
 

Iamdiffrnt

Member
Nov 13, 2005
197
6
19
South of Detroit, MI
Nov 27, 2007
#11
  • Nov 27, 2007
  • #11
I think what 66forfun meant was, there may be a ring worn into the yoke where the seal rides. Which may be part of the cause for your leak.
 
You must log in or register to reply here.

Similar threads

C
C4 trans help needed
  • CPH89LX
  • Apr 26, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
6
Views
224
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Apr 28, 2026
CPH89LX
C
S
Need help 94 GT convertible top leaking
  • Scott94gtvert
  • Aug 9, 2025
  • 1994 - 1995 Specific Tech
Replies
1
Views
167
1994 - 1995 Specific Tech Aug 9, 2025
General karthief
K
4r70w transmission problems
  • Kiddmustang
  • Jul 14, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
5
Views
103
1996 - 2004 SN95 Mustang -General/Talk- Jul 21, 2026
squeak93
M
Drivetrain T5 Transmission Leak at Tailshaft
  • MDrisc
  • Jun 17, 2025
  • Fox 5.0 Mustang Tech
Replies
6
Views
415
Fox 5.0 Mustang Tech Jun 18, 2025
AeroCoupe
Water leak from hatchback door
  • jeremyzcook82
  • Nov 24, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
4
Views
200
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Nov 25, 2025
jeremyzcook82
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1965 - 1973 Classic Mustangs -General/Talk-
  • Classic Mustang Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?