I am getting custom spark plug wires due to the P heads that require 90 degree boots. since my car is apart would anyone know the answer to these questions below to get them made by the company? :
Length required for each cylinder (measured terminal to terminal, not end to end)
Boot style (M or F) and angle (90°, 135° or 180°) for each end (distributor and plug) for each cylinder (if cylinders vary)
Coil wire (if required) Length, Boot style and angle for each end.
Length required for each cylinder (measured terminal to terminal, not end to end)
Boot style (M or F) and angle (90°, 135° or 180°) for each end (distributor and plug) for each cylinder (if cylinders vary)
Coil wire (if required) Length, Boot style and angle for each end.