This is a stock 86 302 in a F-150 4x4
So far I have changed the TFI, coil, plugs, wires, cap, and rotor. Timing is set properly. Compression check done. 150-145 across the board. #1 a little low at 140.
In park and neutral the engine will run decently with a little shake. and rev up easiely. Went put into gear the engine shakes and there is a major power loss takes awhile to accelerate.
I am stumped. What could be causing this?
So far I have changed the TFI, coil, plugs, wires, cap, and rotor. Timing is set properly. Compression check done. 150-145 across the board. #1 a little low at 140.
In park and neutral the engine will run decently with a little shake. and rev up easiely. Went put into gear the engine shakes and there is a major power loss takes awhile to accelerate.
I am stumped. What could be causing this?