Search results

  1. B

    UPR boostmaster bypass valve

    So i just installed the plastic UPR boostmaster pipe but am having problems with the bypass valve that i rigged up. i used a 90 degree elbow from home depot and attached one side to the pipe with some PVC glue and the other side clamped to the hose from the bottom of the bypass valve. it worked...
  2. B

    Surging / bucking at low speed / RPM

    Having an issue with my car surging / bucking at low speed / RPM. If I’m slowly driving through a parking lot, the car will begin to surge and buck and gradually get worse and more violent until I push in the clutch and let the idle catch back up again. Then it will be ok for a few seconds until...
  3. B

    Air/Fuel and Vaccum advise

    Im going to run an air fuel meter and vacuum gauge to better understand why my car is not happy at idle and WOT. What should a 302 with a blower, heads and E cam usually show for for vacuum? What about the air fuel at idle and W.O.T? Thanks in advance.
  4. B

    Supercharged fuel, timing, gap, etc...settings

    Looking for some advice on performance settings on my 91’ stang. It have a 302, Vortech s-trim running the stock 8 lbs of boost and FMU and 24# injectors. Car also has edelbrock heads and Vortech upper and lower manifolds. Looking on recommendations for fuel pressure, timing, plug gap and any...
  5. B

    Supercharged Plug & Gap Advice

    Can you guys advise me on the recommended plug and gap for a vortech supercharged stang with Edelbrock performer heads. Thanks in advance.
  6. B

    Convertable door belt molding removal

    Does anyone know how to remove the door belt molding on a fox body vert?? Mine are all weathered and need to be replaced or painted. Either way I'd like to take them off 1st if its not too involved.
  7. B

    Inner Fender plate for intake tube

    I have a powerflex intake tube for my supercharger on my 91 vert and i need to get a plate that mounts to the inner fender for the tube to go into. i know its for aesthetics but can this be bought separately as what i have did not come with one??
  8. B

    Advise on making engine bay look better

    So i have a 91' blown stang and am just tired of the engine compartment looking like it does. compared to my SRT Charger the engine compartment looks....well just sloppy. What are some ways to simplify the look and make it cleaner in overall appearance. here is a photo of what i have now...
  9. B

    17" speedline saleen wheel cap

    I have a set of 17” Saleen Speedline wheels and am missing a center cap. I have found where to get the decal but need the cap. Any suggestions. I need to replace it before I put my car for sale 
Top Bottom
Back
Forums
Menu