Search results

  1. Slobin3d

    86 Mystery Mods Progress!

    I can't figure it out, can't think of any good reason
  2. Slobin3d

    86 Mystery Mods Progress!

    I made new tangs out of old blown fuses, and soldered them on to the nubs, maybe this will work.
  3. Slobin3d

    86 Mystery Mods Progress!

    Right!!
  4. Slobin3d

    86 Mystery Mods Progress!

    If it isn't one thing it's another..... Got everything hooked back up, and all the tabs inside the MAF have been removed... WTF!!
  5. Slobin3d

    86 Mystery Mods Progress!

    I had/am considering finding a 86-88 harness and just buying a MAF adapter. But this all will work, eventually
  6. Slobin3d

    86 Mystery Mods Progress!

    Saved the best for last. Lol
  7. Slobin3d

    86 Mystery Mods Progress!

    So.... This is what I've found out. I have a complete 92-3 harness from the computer to the fuel injection. I've gone through it all and fixed nearly all the crap splices and junk solder, with good soldering and shrink tube. I'm down to the 8 pin connector on the drivers side fender and the...
  8. Slobin3d

    86 Mystery Mods Progress!

    Started to do repair work. Looks like it's mostly the 86 harness, but the injection harness looks like it's from an 89 or later based on the only factory date codes I could find. Pulled the intake to clean up the vacuum and make harness removal easier. DO NOT USE BATHROOM SILICONE. Cleaned...
  9. Slobin3d

    86 Mystery Mods Progress!

    I'm finding all kinds of changes, in the pic above the red wire on the plug has been cut and spliced into whatever that block is and runs to, under the hood I found by the test port, the green /yellow cut and spliced into what looks like brown. Some sort of old school computer bypass? I'm...
  10. Slobin3d

    86 Mystery Mods Progress!

    Found these tucked into the kick panel with the computer, another relay and custom wiring, and another unused plug
  11. Slobin3d

    86 Mystery Mods Progress!

    I got the A9l today, getting ready to start installing it, and I keep finding open connectors. These 2 and a home made relay, up front on the pass side out of the same trunk line the MAF is in.
  12. Slobin3d

    WTB/Trade Iso: Ar Center Caps

    I'm looking for 2 90's style American racing center caps. Located in Sullivan In. 4 lug wheels on my 86 t-top hatch 5spd 5.0
  13. Slobin3d

    86 Mystery Mods Progress!

    Side note? Once I get the wiring sorted, I have a MSD 6 non limiter version I was going to use on my 460 truck engine, is that something I can run with the computer control, or should I save it for my carbed 460
  14. Slobin3d

    Runs Horrible When Cold

    Tps? Poor ground?
  15. Slobin3d

    V6 Parts Car For 5 Lug Conversion?

    They don't have the same 8.8 disk brake rear the v8 cars do. Well thats no good.
  16. Slobin3d

    V6 Parts Car For 5 Lug Conversion?

    There are several 6cyl sn95s on the local CL for $500 or less, is it worth buying one to do a 5 lug conversion? Can you swap the entire rear end, and front end, or piece meal it and still have to buy conversion parts?
  17. Slobin3d

    86 Mystery Mods Progress!

    Hopefully it's not a scam, it was the last one left and I snapped it up as soon as I saw it. I had one on my cart for 275, and it showed this one as also available at a lower price w/ free shipping
  18. Slobin3d

    86 Mystery Mods Progress!

    Amazon, it was new reman w/ warranty $200. Probably more then I should, but too late now. Thanks for the graphic. I think I may pull the entire engine harness and start checking everything off
  19. Slobin3d

    86 Mystery Mods Progress!

    I ordered a A9l computer. Looking at the harness, it doesn't look like the MAF has been spliced, is it possible that either the explorer or later model mustang harness was used? Is there a good way to ID it. Seems like maybe he ran out of time or money to finish the conversion? Or fried the...
  20. Slobin3d

    Project Check2Check My 72 Restomod

    It's in the booth! First shots of color in the jambs.
Top Bottom
Back
Forums
Menu