Search results

  1. D

    95 GT Distributor install

    Makes sense, I will either get assembly lube or just use plain oil on gear. Thanks
  2. D

    95 GT Distributor install

    I know this is a old thread, but I'm about to replace my dizzy and wanted to know if I need to add any type of grease to the gear? If so is grease from my grease gun ok?
  3. D

    Ac Low Pressure Port Location

    thanks, the car has never had the ac recharge. It stop blowing cold air maybe 3 to 4 yrs ago and never really did anything to fix it. I'm guessing a recharge might bring it back to life if not no big deal I can deal with no AC for now.
  4. D

    Ac Low Pressure Port Location

    Need help figuring out which port is the low preesure on the AC system. Most likely my refrigerant is low since I get hot air when switch on to MAX. I did test the low pressure switch by jumper method and within 15 secs compressor kick on. I did not want to cause any damage and check...
  5. D

    Help With Engine Codes Car Code 172 HEGO (HO2S) sensor fault/lean

    here's an update after re-testing ECT and Codes: 1st after clearing codes, they cam back two days latter: SENSOR TEST OK ;> Code Store in memory: 172 HEGO (HO2S) sensor fault/lean Now for ECT TEST: Disconnected connector and test for voltage got 4.57V With connector plugged in I got 3.71V /...
  6. D

    Help With Engine Codes Car Code 172 HEGO (HO2S) sensor fault/lean

    Yes I got the 3.5V with the pigtail disconnected and probed the socket connector with key on position. Rest where with the sensor and pigtail connected and back probe the connector for voltage Will have to re-test and make sure, thanks once again.
  7. D

    Help With Engine Codes Car Code 172 HEGO (HO2S) sensor fault/lean

    I finish testing the ect sensor, here are the results (Voltage): Disconnected connector and test for voltage got 3.5V With connector plugged in I got 1.61V (Engine cold) "" "" (Engine Mid Warm) .78V ""...
  8. D

    Help With Engine Codes Car Code 172 HEGO (HO2S) sensor fault/lean

    UPDATE: 2-9-09 Ran code reader this time at normal operating temps: Now I Get NO SENSOR ERROR CODES: CODES 116 - Engine coolant temperature higher or lower than expected - GONE 636 - Transmission Oil Temperature higher or lower than expected = GONE BUT NOW HAVE THE FOLLOWING CODES...
  9. D

    Help With Engine Codes Car Code 172 HEGO (HO2S) sensor fault/lean

    OK that makes sense, will try that sometime this week. I would rather not replace good parts with new ones, Plus I'm learning how these things work.
  10. D

    Help With Engine Codes Car Code 172 HEGO (HO2S) sensor fault/lean

    Ok I did the Resistance test, but I was not able to get any voltage from the sensor only resistance. This is how I tested it for Voltage and resistance.. With key on position and disconnected harness I hook up volt meter and was able to get resistance but no values for voltage the 2 pins on the...
  11. D

    Help With Engine Codes Car Code 172 HEGO (HO2S) sensor fault/lean

    OK, How easy is it to get to the ECT sensor? location on the manual says it's at lower intake. Included Pic. Laso found instructions on testing it at: TESTING ECT SENSOR Since it was nice out today I cleaned the maf sensor and re oiled the K&n Filter. Still drying the filter so couldn't test...
  12. D

    Help With Engine Codes Car Code 172 HEGO (HO2S) sensor fault/lean

    Need Some help to deciper the following codes: I get the Following Fault Codes For Sensors ( I tested it with getting engine to running Temp so I believe this what causes these codes) CODES: 116 - Engine coolant temperature higher or lower than expected 636 -...
  13. D

    The get rid of the junk in your garage thread!

    Anyone have a driver Side Mirror for a 94 GT? Does have to have mirror just need the everything else. Mine decided to shear off all three pins holding it tody!! Anyone know A good place I can order one at a fair price?
  14. D

    Need Help Fast Please Wire Came off my Brake Pedal Switch Where does it go?

    will this work on automatic? or is this only for manual trans.. Hiss, yes I popped off the cover and removed the spade connector and soldiered an addition piece of wire (1.5 to 2") and connected to the wire. Looks like it failed due to shear stress (wire to short) abd age. Just glad it...
  15. D

    Need Help Fast Please Wire Came off my Brake Pedal Switch Where does it go?

    I figure it out, remove connector and was able to see where it broke off
  16. D

    Need Help Fast Please Wire Came off my Brake Pedal Switch Where does it go?

    The Red/Green Wire Came off and I have no clue where it goes to.. Right Now I can Start The Car but cannot get the car out of Park.. This is a Automatic, Attach Pick.. I'm stuck in driveway Help...
  17. D

    Kill switch help

    I would do a fuel pump cut-off.. I 'm sure someone give you more info. BTW fuel pump cutoff would be somewhere in drivers seat area
  18. D

    How do I clean the MAF ?

    I located the MAF in the plastic housing. Now I see the sensor thru the wire screen. what do I remove to reach to the sensor to clean it. I was albe to spray some brake cleaner non-residue type tru the screen side. On the other side is a metal plate held down by 2 screws do i remove...
  19. D

    Fog light switch LED (hissin5.0???)

    just gave me a idea.. maybe replace bulb with a different color?
  20. D

    Good site for fixing collision damage

    2 sites I visit alot: http://autobodystore.com/forum/index.php http://www.corral.net/forums/forumdisplay.php?f=305 good luck
Top Bottom
Back
Forums
Menu