Search results

  1. S

    Best Nitrous Spark Plug???

    Im running the stock castings. E7TE's. Im taking the 3923's out right now and Im putting the Motorcraft in now. Zex makes thier own spark plugs for nitrous applications but I dont really trust a plug made by a nitrous only company, ya know. Are the Autolite 3924's good for nitrous use?? I know...
  2. S

    Best Nitrous Spark Plug???

    like the Denso's??
  3. S

    Best Nitrous Spark Plug???

    I recently installed a Zex kit on my car and wanted a good plug to use. I switched from the stock Motorcraft plugs I always run to a colder plug, Autolite 3923's. The car has a BAD miss now and Im putting the old ones back in in the morning. They are gapped correctly and the little shims or...
  4. S

    Who has Zex?? Ive got ????

    oh, come on guys.....help me out
  5. S

    Who has Zex?? Ive got ????

    OK, just got the kit with no instructions. As far as the box goes, the 2 rubber lines say "Regulator" which Im assumimg goes on the top of the fuel pressure reg. and the other says " intake". Where on the intake does it go?? And the wiring: red= 12 volt supply :black=ground : white=to the...
  6. S

    gas for 5.0

    If Im running 10:1 compression and shooting 100hp dry shot,and I retard the timing 2.5* for each 50 shot, would I benifit from running 118 octane race fuel at the track only to make sure I dont detonate when spraying? What are your thought on this concept? Thanks for the help........
  7. S

    lower c-arm bushings.......where to get??

    I have MAC lower and upper control arms in the rear of an 88GT. The bushings that go to the rear end are shot on the lowers and they are telling me that I cant replace them and need new control arms. I find that rear hard to believe, since the oem bushings are probably the same size. There are...
  8. S

    lower c-arm bushings,.....where to find??

    .
  9. S

    My car runs like crap

    $100 says its the 02 Sensors........
  10. S

    Replacing power steering rack...

    If I remember correctly, the bushings are going to give you the biggest problems of the whole job. You may need to get new ones and have them put in the new rack for you before you take it to the car. So you have a nice new complete assambly to install. If the car is lowered, you might want to...
  11. S

    Replacing power steering rack...

    either or, if worse comes to worse you can do it with just the jack. Trust me.......But make sure the car is securely supported for safety sake. With hand tools and no breaks your looking at 3-4 hours roughly. Some might object that estimate, but the last time I did it I had a lift and air...
  12. S

    Ignition Module

    Simply mark the spot the dist. is at now at the base of it and loosen the hold down bolt (1/2"). Take off the module, be sure to clean the surface behind it and add new module compound/dielectric grease. Install the new one and return your dist. to the old setting. As long as the car is not...
  13. S

    MAF Conversion compatibilty Question!

    If Im not mistaken, the A9L is for the 5 speed and the A9P is for the Automatic. Now a computer for an automatic will work for the 5 speed as will the A9L, But only the auto computer can run the Automatic transmission equiped cars. Just for GP..........
  14. S

    Why is my car not faster?

    The plastic box on the top of the housing is actually the sensor, not the big round aluminum housing. The plastic box should have 2 screws in it and the sensor comes out. If the screws are the original ones they are tamper proof and you need special hex bits to get the sensor out. If not pull...
  15. S

    Why is my car not faster?

    Also have you checked your codes yet??
  16. S

    Why is my car not faster?

    Clean the MAf sensor wires with a q-tip and some rubbing alcohol. Our drag car picked up 3 tenths by cleaning a filthy MAf sensor. If possible pull the sensor out of the housing and cleaning the wires will be much easier. If not spray some contact cleaner on the 2 wires, but they must be dry...
  17. S

    Why is my car not faster?

    What is your timing set at and fuel pressure??? Also what is your TPS at?? Also was the MAF sensor used when you got it??
  18. S

    Why is my car not faster?

    Try recalibrating the g-tech and make a series of passes (3). Then take an average of those and go from there. Are the mods you listed the olny done to the car?? And are you still speed density??
  19. S

    Why is my car not faster?

    That could be pretty close depending on milege and driving. Not to piss you off but the internal wear of your engine significantly decreases power to the wheels on a high milege engine. The stock gear is killing you!!! And traction on the street is a lot worse than on a hot sticky track. Just my...
  20. S

    Throttlebody ?'s

    You wont notice a significant difference between the 2 for what its worth. Some say 65 and others say 70mm. I say for drivability purposes go with the 65mm FMS. Only because the TPS on it is a better quality sensor and the casting is almost flawless. But you will pay for it......
Top Bottom
Back
Forums
Menu