Search results

  1. RBRANDX

    AN Fuel line....help me out !

    I dont even know if this is the right place to post this....But, here goes..I am looking to buy a roll of an-8 braided fuel line, and a roll of an-6 as well....I have searched the forums and googled the crap out of this, but cannot seem to find out where to buy this? Anyone know from experience...
  2. RBRANDX

    93lx 5.0 conv for possible trade/sale

    read below....opinions on how much this car may be worth....
  3. RBRANDX

    Need help with proper backspacing..86GT W/Cobra brake upgrade

    Ok, I know someone should be able to help me out with this one..My 86 GT had been converted over to the 13" Cobra brakes using 95 GT spindles and the North Racecars rear brackets. The stock length Fox body axles were retained, leading me to this question....What do I need to do/what...
  4. RBRANDX

    Best place to buy Cobra brakes...experiences??

    I know many of you guys have been down this road before, so I wanted to get everyones input....Where would be the best place to buy Cobra calipers/rotors ( cheapest, best service, fastest shipping, etc...) Thanks!
  5. RBRANDX

    Master cylinder conversion, what size fittings? Help!

    OK, finishing up on my brake conversion ( 86 GT to SN95/Cobra R spec.) and need a little help from all you guys who have done this already. All I have left to do is install the master cylinder ( 1995 GT unit), and need to know what size fittings I will need on the hard lines from the prop valve...
  6. RBRANDX

    SN95 Guys, need help with a nut size. ( no, not what you think!)

    I have just installed the SN95 brake booster in my 86 GT and need to know what size nuts I need to bolt the MC to the booster. Thanks.....To late to take the boster to Lowes and find out for myself...
  7. RBRANDX

    Ditched the FMU..need a "base" setting

    T-trim s/c'd 331, H/C/I, switched to #42 injectors, no more FMU, anyone running a similar combo? I just wanted to see what you have your fuel preessure set at as a "baseline" until I can get this thing on a dyno..I will be driving the car there ( 100 miles ). Thanks.
  8. RBRANDX

    Need intake opinions/input for s/c'd 331

    I have been beating myself up over this for a while and wanted to get some solid opinions to help sway my decision...I am running a DSS 331, ported edel. rpm heads ( 2.02/1.60 valves), 70mm tb, 76 mm C&l MAF with a T-trim Vortech ( power pipe/ 2.95/7.00 pulleys) and about every bolt on you can...
Top Bottom
Back
Forums
Menu