Search results

  1. fox-gt

    Seat pigtail question

    Seat Pics Finished up late tonight so the pics are not that great Thanks to everyone who responded / helped
  2. fox-gt

    Seat pigtail question

    Looking at this: http://www.stangdriver.com/files/PigtailIdentificationKit_2of2.pdf Could it be this one? WPT376 3U2Z-14S411-EDA
  3. fox-gt

    Seat pigtail question

    I'm getting ready to bolt some 04 seats into my 93 GT. I was wondering if anyone knew the part number of the female end of the connector below. Also, are the bottom posts power and the top left ground (top right not used)?
  4. fox-gt

    If your gonna break a seat, do it right

    Should i just weld around the break or does it need support? I'm new at welding, but I'm going to give it a try.
  5. fox-gt

    If your gonna break a seat, do it right

    front bolt and back bracket :fuss:
  6. fox-gt

    Mach 1 gas mileage and reliability

    Mine is my daily driver. I drive about 75 miles a day. It averages 17 to 19 mph, but I drive like a jackass.
  7. fox-gt

    Am I the only one with this bad of luck?!?!

    Engine rebuilt with less than 5,000 miles, oil pouring out of every place it can, builder will not return calls. I can't drive it cause of the smoke pouring off the exhaust. Car was repainted in 2006, one month later a piece of drywall flew off a truck and hit the hood, bent the antenna and...
  8. fox-gt

    How much should a tune up cost

    I am new to modular engines. I know a tune up on my fox cost me about $100 for plugs, good wires, etc. I called the local ford dealer and they want $295 for a tune up on my 04 Mach. That seems REALLY high to me. :shrug: They said the service included: change plugs and wires set...
  9. fox-gt

    vaccum lines/ nee pics

    pardon my poor drawing skills: HTH some
  10. fox-gt

    Price on a rebuild

    Mine was $1,000 for all the block work and parts (new pistons, rings, etc) to go from a 302 to 306. $600 to disassemble, take out and reassemble. The guy who reassembled mine really jacked it up, so make sure you take it somewhere reputable.
  11. fox-gt

    Quick! Fox body common problems? What to look out for?

    Some of it depends on what you want to do with the car. Mine died at 144k miles, it was a daily driver. Others on here have 200k+ out of them
  12. fox-gt

    Lets see some pics!!

  13. fox-gt

    Map Light Bulb?

    Sylvania's website shows it as a 105 also http://www.sylvania.com/ConsumerProducts/AutomotiveLighting/LampReplacementGuide/ 1987 FORD Mustang High & low beam headlamp 9004 9004SU Silverstar ULTRA for Ultra Night Vision - The Whitest and Brightest Halogen 9004ST Silverstar High...
  14. fox-gt

    drove a 4.6....hmmm

    I have a Mach 1 for a DD. Everything about it is different than my Fox. Not good or bad, just different.
  15. fox-gt

    BBK H-Pipe fitment problems

    My experience with my BBK shorty headers and BBK H-Pipe has not been that positive. The gaskets that came with the headers crumbled after two weeks, they had to be replaced. The headers and the steering shaft issue are a valid point. Even after new motor / tranny mounts (prothane at that). I...
  16. fox-gt

    BBK H-Pipe fitment problems

    I had major problems with my BBK H-Pipe. It has never fit right. I'm waiting on it to finally rust out to get a new one. It is one of the reasons I'll never buy anything BBK again.
  17. fox-gt

    Which motor mounts?

    I went with Prothane because I wanted to raise the engine. I can definitely tell there is more vibration over the stock rubber ones, but I'm happy with them.
  18. fox-gt

    pypes violator catback

    I'm getting ready to put one on my 04 Mach 1
  19. fox-gt

    In the middle of a clutch swap, need help

    The performance shop who sold me the replacement flywheel sold me the wrong one. I had to go to autozone a few cities over to get a replacement. Thanks for everyone's help.
  20. fox-gt

    In the middle of a clutch swap, need help

    are the balanced the same?
Top Bottom
Back
Forums
Menu