Search results

  1. RED92VERT

    Grease driveshaft?

    On the splines just put some tranny fluid
  2. RED92VERT

    Is getting a midpipe with cats worth it?

    The only downside to the SLP pipe is it hangs low. I scrape all the time since my mach is lowered.
  3. RED92VERT

    Running rich or what?

    Have the car Dynoed and it will tell you if you are running rich. My car does it and i have an A/F of 12.9
  4. RED92VERT

    Question about exhaust

    All exhaust systems will have diff sounds at diff RPMs. My magnaflows are quiet until i hit 3k and then they scream.
  5. RED92VERT

    Best Performing Exhaust?

    I have had flowmasters, Spintec, Dynomax, and magnaflows on my stangs. The one that i like the best is the magnaflows. They sound great and arent to loud until i stomp on the gas.
  6. RED92VERT

    Help on tires for 2000GT

    I have tried almost every tire on the market, and the tire i like the best is the Toyo Proxy T1-S. It drives great in the rain and grabs hard when its dry, and is great for cornering. A set should be good for 20k miles.
  7. RED92VERT

    what do u think it will run?

    For drag racing get the 4.30s i have the 4.10s in my mach and wish i went with the 4.30s. This summer i will be swapping them out. Going from 355s to 4.10s i noticed 2mpg diff.
  8. RED92VERT

    Best Performing Exhaust?

    Check out this review of all the catbacks http://www.mach1review.com/CATBackExhaustSystemsReview.html
  9. RED92VERT

    Is getting a midpipe with cats worth it?

    I have an SLP offroad X, the cats bolt in and out. Its much easier than switching out the whole pipe. There is a big diff between the highflows and the offroad. I barely even use my cats anymore.
  10. RED92VERT

    Gears

    The 315s might slow your rev down, due to weight. Id say 13.7 with the gears.
  11. RED92VERT

    How To Beat a WRX with a 03 Vert ?

    If i were you i would get an offroad X pipe, 4:10 gears, and a Zex wet kit Jetted for 75hp just in case he starts to pull. Unless he has a fat turbo he should be no problem.
  12. RED92VERT

    Leaf spring recommendations and advice

    Give maier racing a call, they were very helpful when i was setting up my 66. http://www.maierracing.com/
  13. RED92VERT

    Mach 1 Bought A Mach 1

    I recomend doing the gears, i havent noticed any diff in gas milage. I recently got 24.5mpg with the 4:10s on the highway. The first mod to do is Tires, second mod ditch the cats and after that do the gears. My car felt so much faster once i got rid of the cats and got the 4:10s. When you do the...
  14. RED92VERT

    Steeda Tri-AX Shifter

    Put your stock shifter back in and see if you still have the problem. If you do take it to the dealer. If it goes away call steeda, they might replace it.
  15. RED92VERT

    Adding power brakes to 66

    I dont think that will clear the clutch linage, but i could ge wrong.
  16. RED92VERT

    Strut/Shock Install Question

    Ive done countless numbers of struts on mustangs and i aways used the impact gun with no problems. Just make sure it isnt a high torque gun and you are gentle with the trigger.
  17. RED92VERT

    Strut/Shock Install Question

    Once the car is jacked up and the wheels are off, make sure you put a floor jack under the A-arm. Take the lower two bolts off the front strut. The top nut is hard to get off and will most likely need an impact gun. The strut should now be free and remove it from the car. Take the dust shield...
  18. RED92VERT

    Are you thinking of a new shifter?

    The $99 upr shifter is tempting, but i think im going to get the MGW also.
  19. RED92VERT

    New TB & Intake Manifold...

    If it is your first time installing a manifold make sure you remember where every thing goes. I labled everything with masking tape my first time. Also be careful when you take off the stock lower intake bolts. I had one that corroded over the years and it broke in my head. Also the manifold can...
  20. RED92VERT

    94 control arms/spidles on a fox

    Not positive but i think that the 94 arms are longer than fox body arms. Maybe someone else knows for sure. When i did my 5 lug conversion i used the stockarms with SN95 spindles and brakes.
Top Bottom
Back
Forums
Menu