Search results

  1. shawn13

    coil on plug

    How can I test the coils on my car? I now have a miss at high rpms(5000 and up).The rev and speed limiters are off plus went back to the stock tune just to make sure it wasnt them. thank you
  2. shawn13

    hickup

    Well I pulled the plugs they looked like crap heavy brown buildup...I dont run additives!! Cleaned them all and the butt dyno says it runs a lot better.
  3. shawn13

    hickup

    This might help,I sent doug a e-mail of this,He is a great person to work with..Thanks 05xgt
  4. shawn13

    hickup

    Dynoed my 06 and she has a miss at 5500rpm.They told me it looked like a ignition miss. any help would be great thank you..
  5. shawn13

    Bama Chips

    Chad9350 I went out and ran it to red line in all 4 gears and never missed a beat, you should get that fixed....The race tune pulls harder all the to redline,the tourq tune fall off around 4500.just my 02 both are great
  6. shawn13

    Bama Chips

    Got the new tune for my S&B intake,93race and wow but the 93 Torq is really nice too.Im at cross roads but the race tune will stay in. Thanks Doug
  7. shawn13

    make a driveshaft

    I looked in too having this done, its not realy any cheaper by the time the shop gets done with you.....
  8. shawn13

    make a driveshaft

    Iv heard that you can make a Ranger shaft fit the 05 06 cars..... Can it be done??
  9. shawn13

    Hurst Shifter..."Notchamatic"

    I like mine no vibe or rattle but it is kind of stiff.Overall nice addon though.
  10. shawn13

    rear differential noise

    Is the moan on tight turns hurting anything,or are the clutch packs just to tight.I dont want to take my mods off just for a trip to the dealer .Thanks
  11. shawn13

    Bamachips How long

    A one man show ! That a lot of work buy ur self more power too him.. Thanks Pro Mod
  12. shawn13

    Bamachips How long

    How long of a wait is it for your order? I ordered on 3/2/07 but have not heard anything yet just woundering if any knows..
  13. shawn13

    Speedo Drive gear

    The 7 tooth drive gear is in the trans,pull out the speedo gear and look in it ull see it then
  14. shawn13

    Switched from EFI to Carb,, NEED HELP!

    Just run a power wire that turns on and off from the key switch
  15. shawn13

    budget heads?

    Peak Intake Flow @ 28" .700" lift 276 Valve Sizes/Length 2.020"/1.600" Manifold Edelbrock 5021 Intake Gasket Fel-Pro #1262 this is what the link he gave has
  16. shawn13

    budget heads?

    You should check out thumpers heads,,,, those pro heads are high flowing at its full flow rate but thats at .700" lift
  17. shawn13

    worked stock or gt40p heads

    PM thumper460 I think you will like his work better than gt40p heads
  18. shawn13

    help!! 91GT supercharged misses at high rpms

    So its just missing under a load!!! I would start with fuel pressure and fuel filter then plugs, wires,cap and so on
  19. shawn13

    who else goes through clutch cables like oil filters?

    Were are they breaking at the quad,clutch fork,in the sheathing??Do you have it hooked in the right slot on the quad, My quad had burs on it where the cable road in the grove I had to file befor I instaled it you might want too look at it... oops my bad didnt see the breaking at the quad thing...
  20. shawn13

    What goes in the threaded hole in back of block.

    That is the bolt hole for the smog pump lines that went too the back of the head..Oil will not come out of them its just a dead hole......
Top Bottom
Back
Forums
Menu