Search results

  1. C

    Fitting 6.5" coaxial in the doors of an '06?

    Here's what I did with the 6.5 JL componants I installed. First remove the door panel, as you cannot remove the speaker until you remove the bolt from the backside of the door panel. Then you will have to either fabricate or purchase an adapter plate that fastens to the speaker, then the whole...
  2. C

    Stereo Question

    There are some companys that offer double din units, pioneer and eclipse for example. They are kind of pricey but they offer touch screen functions and navigation. I guess it depends on how much you want to spend.
  3. C

    Headlight dimming?

    Install a cap. If your not sure how, ask any install joint. They will point you in the right direction. It's easy.
  4. C

    What will it take to beat an LS1?

    Lots of $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
  5. C

    Steeda Tri-ax Shifter Noise?

    Here's what I did. I pulled out the hard red bushing from the aluminum arm and replaced it with the stock bushing. Next I placed a half inch thick piece of silicon rubber between trans tunnel and the main shifter bodymounting bracket over the long threaded mounting posts. This helped a great...
  6. C

    Few Questions-Stereo Install

    Check out Sept issue off 5.0 L mag. they do an amp and sub addition to a stock head unit.
  7. C

    rattle under car

    More than likely your panhard bar is bumping into your exhaust pipe where the two come very close together over the axle. Mine comes very close after I installed Bassani's and my car is not lowered.
  8. C

    Need audio advice

    Check out the September 5.0 mag. They do a sub hook-up to a stock shaker 500 system.
  9. C

    05 GT engine knocking!!!

    Mine make a lot of "diesel" noise as well. I have read that getting the latest software update from ford may help the problem. It sure does not give the owner of one of these engines that they have a precision built engine by any means. Could it be because the block is aluminum and transfers...
  10. C

    how to anchor a sub box in 2005?

    A write up in the latest 5.0 Mustang mag of an installation of a Scosche 12" sub and enclosure (sept issue, page 149) claim that the mounting holes for the shaker 1000 sub enclosure are already there sealed under some pieces of tape under the carpet. Perhaps you can use those.
  11. C

    Under dash heat

    Has anyone else noticed a lot of heat in the gas pedal area? I don't normally drive with the A/C on as the temps around here have only being around the mid 70's and I don't think I should have to just to keep my feet from cooking. I had a look under there and noticed that the heater lines come...
  12. C

    Shaker door sub swap

    The label on the woofers I removed from the doors reads as follows: 1.2 ohmx2 60Wx2. P/N 4R3T-18808-AFW M5xug 2524.
  13. C

    Shaker 500...

    It sounds pretty good. You should go to your dealer and listen to it for your self before you decide. The 6 CD changer is real handy. It however does not have much adjustability as far as low mid and highs go. it depends on how much of an audiophile you are.
  14. C

    Will a subwoofer fix my problem?

    Smaller componant speakers are just not able to produce much bass. Several audio write ups that I have read suggest speakers of this size will not produce much of anything below 70 to 80 Hz at any amount of volume. They suggest setting your high pass filter no lower than 70 Hz and backing up the...
  15. C

    Scoche Sub

    Has anyone tried one of Scoche's new 12" fitted sub enclosures yet.
  16. C

    Looking for a Good GPS Attena Location

    I have a pioneer D1 nav in my 05 and the installer put the GPS antenna up under the dash and is not visable from the outside. it seems to work fine.
  17. C

    SHAKER 1000 OR SHAKER 500?????

    The rear speakers are 5X7/6X8. the front is a three way setup. The large bottom speakers are 7" woofers mounted to the door panel that has a built in bass enclosure, the top location is an self contained enclosure with an 3" or 4" midrange with a tweeter that is mounted to an adapter bracket...
  18. C

    Mole skin

    I am planning to have door windows tinted and am interested in installing the mole skin before hand, but I have a few questions. Do you install the mole skin on both inside and out side locations. if installed on outside, how does it stand up to ice and snow? Also where can you buy this stuff...
  19. C

    Any pics of Tri Ax short shifter install?

    A word of advice. Don't drop the drive shaft, what a pain. Instead just install the arm part to the trans, then the main part to the car, then connect the two together under the car. It is a little tight under there, but in the long run it is quicker and you do not have to worry about...
  20. C

    Anyone else notice this?

    Does it perhaps plug into the socket found inside the armrest.
Top Bottom
Back
Forums
Menu