Search results

  1. 0

    will a 95 GT rear end work on my 99??

    it will fit and yes it is narrower. so if you have access to it grab it and get your stang up and runnin again. the 94-99 are all the same chassis.
  2. 0

    Analyze My Dyno

    it starts going dangerously lean in at the end of the pull. if it keeps that up then i wouldnt run the car to the high rpms until the a/f is brought back to the high12/1 ratio. you have the right components, so the pump may need a little more juice to raise the pressure at higher rpms. a BAP in...
  3. 0

    Could someone explain the difference in gear sizes?

    the numbers such as a 3.73 or a 4.10 are the teeth on the ring gear divided by the pinion gears teeth.
  4. 0

    Cold air intake?

    it will be ok as long as you never remove the wheel well liner. the filter is shielded by this. had a 95GT with a fenderwell cai and it was ok but to get more air i removed the liner. it would suck in water afterwards. just stick to the manufacturers instructions and you will be ok
  5. 0

    Screwed Up!!

    the only pin in the rear is the pin that is run through the carrier. it holds the spider gears in the trac-lock. if you had an serious issue you would have most likely experienced it. be glad that the dealership has said it would be a warranty repair if needed. if the rear doesnt whine then i...
  6. 0

    Going to put my old Zex kit on the stang... got Q?

    to find the tps wire you need a multi-meter. spark plugs need to be non-platinum. the programmer will work like was said but retard timing. run as high a octane fuel as possible when you spray.
  7. 0

    Not enough HP for high stall converter??

    the stock converter is tight maybe no more than 1800-2000. the transmission shop may be right. i have seen guys run 2400 stall and be very satisfied. the only way to find out is to call and talk to torque converter manufactures and get suggestions. a 24-2800 to me in my opinion is the way to go
  8. 0

    ABS light

    check the fluids first. then drive the car. it could have something to do with the traction control since the two are linked but i could not say for sure.
  9. 0

    Going to the dyno!

    many things affect dyno #'s. thats why a good dyno shop will include air temp, barometric pressure, and altitude. today is overcast but dont forget that the humidity is kinda high and that could a hurt a little. the other thing that may not help is you have a custom ram air built for your car...
  10. 0

    96-99 Stock Cobra Dyno

    the only ones i know of stock that dyno in the 270ish range are the 99/01's. the 96-98's dyno more around the 250 area. the average drivetrain loss in a manual car is about 15-18%.
  11. 0

    97 / 2000 4r70w interchangeable?

    yes they should be interchangeable. they are the same casings. the only ones that do not work are the aode from the 94-5 gt that only have 2 starter bolts.
  12. 0

    Greyish Blueish Smoke.. Help Please..

    should be normal. as long as it is black puffs. black smoke is gas. blue or white smoke is bad. if you ever see sports cars especially after they are tuned most smoke. vipers seem to be the worst i have seen, they billow black smoke like a deisel truck.
  13. 0

    question about bumper!!

    whoever told you that there are year specific bumpercovers from 99-04 is bs'ing you. the kit as mentioned is one of the most popular ones as it includes fog lights. the only thing needed is the mounting clips and hardware from your car. if you buy one find a good paint shop and make sure they...
  14. 0

    01 cobra brakes

    the calipers are held on by a pin and a c-clip. once those are pulled then a rubber dead blow hammer works to tap the calipers off.
  15. 0

    Exhaust on cobra from gt

    sicne you are swapping motors then the cat back will work. i dont think the headers will fit though. the mid pipe will possibly work as i have seen mid pipes offered for all 4.6 motors regardless of cobra or gt. its not so much the block as they are all the same dimensions but the width of the...
  16. 0

    Electrical short

    well to find the cause you would need a manual with the wiring harness in it. What did you do to cause the short? most wires in the steering column are bundles so you may have a pinched wire that is causing the short. check all your fuses also. well the shop manual will give an idea as to where...
  17. 0

    I just raced an auto GT ...quick question

    2-3 cars, well the gears will give you a slight edge off the line but thats assuming you can hook up, the gears make a difference on the launch and may hurt more there than help. once you are moving they wil help. the race will still be close. you should get the intial jump and lead but that...
  18. 0

    What blower is on this thing???

    with a smaller pulley they become extremely loud under boost. just helped tune one with a 2.80 pulley and that makes a difference. especially in sound. anyone near killeen tx, that car is at AUTOMAX. its an 04 with a pulley, tune cai and bassani cat back. it puts 461rwhp.
  19. 0

    any info/articles on clutch install with L/T's????

    the clutch is not very difficult once everything is torn down. if you get a good kit with an alignment tool its a breeze to install. the hard part is to line up the transmission. there have been a few clutch questions answered recently on stangnet. search around and you will find them. the two...
  20. 0

    Greyish Blueish Smoke.. Help Please..

    piston rings gone bad creating blow by, or bad guides and seals in the heads. you could baby it and try to get the car to last if you dont have the funds for a rebuild just yet, but you have to drive easy.
Top Bottom
Back
Forums
Menu