Search results

  1. J

    help mustang problem

    Have your battery tested, sounds like a bad cell. If you have a bad cell, it will be very hard to jumpstart. Also like it's been said, check your cables too.
  2. J

    Help auto trans /tow dolly

    When towing an automatic, you need to stay at 35 mph for 5 miles. Some automatics are not towable at all. You should have pulled the driveshaft, because you just cooked your trans. I don't believe you got scammed.
  3. J

    Problem with the 347

    sounds like you lost a cylinder.
  4. J

    Anyone with Tremec 3550 knowledge

    Any idea how to get the rear seal for the trans? Is it the same as a t-5? Also, will the speedo gear from a t-5 work in it? Thanks.
  5. J

    Can you recyle tires and get money?

    You for sure won't get money from them, and if you dispose of them properly, you will have to pay a disposal fee, usually $2.00 per tire.
  6. J

    R12 to R134 conversion results

    If you don't pull a vacuum, it WILL NOT be as efficient or last as long. By pulling a vacuum, you remove moisture. That's all. It's that simple. Moisture is a contaminate that will ruin your performance. I know it will work without it, but not like it was intended,or capable of and when you...
  7. J

    Mass air conversion

    Juiced88coupe, what do mean by that? If he has speed density, it is way easier to convert it rather than change the whole harness.
  8. J

    Putting a SBC in a Fox...

    First off, he politely asked to keep the comments to yourself. Secondly, maybe he is a chevy guy and likes the fox body, it's his car, let him do what he wants. Now, I've got a friend with a 86 that was a 4 cyl, he welded plates for the motor mounts (ghetto) and rigged up a trans mount. Used...
  9. J

    Removing Pilot Bearing?

    I have a tool that pulls it off, instead of the impact from a slide hammer. But that works great too.
  10. J

    R12 to R134 conversion results

    He went to a shop, and they probably replaced about everything. The only thing you need to change really is the drier. But, he should have a warranty and if you can't do it yourself, that's the price you pay
  11. J

    Engine vibration help!!

    EDS, we have the same problem. I'm changing mine tomarrow, let me know if it solves your problem, also if your running the clutch fan, make sure it's messed up.
  12. J

    Mass air conversion

    Just get a mustang mass air computer, and wire the sensor into the existing harness and your good to go, took me about an hour start to finish, and it works great
  13. J

    R12 to R134 conversion results

    R134 runs at a higher pressure than r12. R12 is more efficient than 134. But with the ozone and the price, a 134 retrofit is well worth it. There is an additive called freeze 32 for older cars doing a conversion, I've seen the results, it works well, it will make your ac 5 degrees colder. If you...
  14. J

    Engine vibration help!!

    Mine vibrates with the clutch pedal pushed down sitting still, and as far as my two flywheels, one has a smaller clutch than the other. But the splines are the same, I'm just going to buy a new clutch and flywheel.
  15. J

    dropping tranny, how to disconect driveline from rearend?

    I have a 12mm 12 point swivel socket for a 3/8's impact, and they fly right off like who dunnit. I'd use heat if I didn't have the socket with an impact though.
  16. J

    Engine vibration help!!

    I've got the same issue, but I almost think I have the wrong flywheel, is there a way to tell what balance a flywheel is? I had two, one off a 87 and one off a 91 (supposedly), I used the 87 one, and now I have the wicked vibration. The only thing that worries me is the flywheels looked...
  17. J

    How far have you pushed a T5-Z?

    Maybe your throwout bearing is junk.
  18. J

    4cyl trans?????

    They are 100% completely different. Sell it on ebay, or use it as a boat anchor.
  19. J

    AOD Tranny Service?

    I agree with ponyboy19, get it flushed if it's been serviced before. Is your fluid burnt? If it is, DON'T touch it, if you do, get ready for a rebuild.
  20. J

    Help! AOD going bad, what to do now??

    Get it rebuilt, use a lentech valve body or a trans-go shift kit. Buy the "taxi/police" sprag so you can have 2 more direct drive clutches. Get a nice little stall converter, and you will be happy. There is no way a t5 swap is cheaper, and if you did use a t5, with the hp you have, you will...
Top Bottom
Back
Forums
Menu