Search results

  1. B

    pinging should i run spout out??

    9
  2. B

    pinging should i run spout out??

    has anyone tried running timming locked spout out to help the 94-95 pining problem???
  3. B

    clutch advice for a STOCK 95 GT

    you have me beat on the trani, but i still have the orig clutch too!!:SNSign:
  4. B

    Has ANYONE found out the vibration prob?

    you have to realy tighten the drive shaft bolts, look how tight the fact has them, I put wd-40 on them and smack the wrench with a big hammer to get them tight enough
  5. B

    Hard Upper Radiator Hose...is this normal?

    take the rad cap off COLD and start it and look for bubbles, might be headgasket time
  6. B

    Has ANYONE found out the vibration prob?

    YES i just did checked the harmonic balancer it was good, turned out my front universal joint was bad, bearings ground to dust dxxxx only got 170.000 out of it:shrug:
  7. B

    found my vibration

    checked the harmonic balancer ,it was ok put new wires and plugs in it ,ran better but turned out it was the front UNIVERSAL JOINT, bearings ground to dust
  8. B

    Clutch cable OK with 135k?

    Dxxxx he has me beat !!!:hail2:
  9. B

    clutch advice for a STOCK 95 GT

    i dont think i have to worry about the t-5 my wife has 170.000 on the original never worked on t-5
  10. B

    how long will a timing belt last???

    thanks for the help!!! anyone else???
  11. B

    Clutch cable OK with 135k?

    my wifes 95 GT still has the stock orginal clutch cable, 170.000
  12. B

    how long will a timing belt last???

    I did-not know the 2.3 would bend valves with a broken timming belt
  13. B

    Summit is producing new 302 blocks now?? Anything special about them?

    those 5.0 roller motors came in trucks and mec grandmarqe,s, mustangs who nows what else, heck the junk yards are full of them
  14. B

    how long will a timing belt last???

    how many miles did you get out of your timming belt??? thanks
  15. B

    Another “which mods next”?

    you might have to spend money on a stroker kit
  16. B

    clutch advice for a STOCK 95 GT

    thank you, now is the heavy duty from motorsport ,stock???
  17. B

    should i have the flywheel turned

    has anyone replaced the clutch without having the flywheel turned ?, and did it work out ok ? Thanks!!!!!!
  18. B

    vibration in motor,after shift balancer??

    Im begining to think its in my clutch, I put new wires and plugs in the car, but no better ,then I took the balancer off and put it on top of a new on at autozone and the keyway and timming marks lined up, 2 weeks ago the car had a funny rattle under it so i tore the remaining heat shealds off...
  19. B

    clutch advice for a STOCK 95 GT

    what clutch came stock in my 95 GT?? king cobra or heavy duty?? and what clutch should i put back in???? keep in mind the car is stock and a daily driver??, and will always be a daily driver, I have a mustang that is moded and dont need 2 Thank you!!!!
  20. B

    Anyone ever replace a backing plate on rear drums?

    I had the same problem on a 87 camero ,the wheel cylender,s kept blowing out ,couse the shoe was going on an angle and the brake shoe wore at an angle, yes i had to remove the axles
Top Bottom
Back
Forums
Menu