Search results

  1. L

    does gear whine go away with break in

    gear noise is usually caused by impropper installation but with the gears being used, it could be that. either way the sound wont go away
  2. L

    Foxbody vs 03 cobra engine

    turbocharged 408...........a couple revs of the motor and he'll shut up. wont even take a race
  3. L

    so whos all running the infamous afr 165s on stock shortblock?

    i run them on my 92 hatch. very well made head. running the stock block, cam, crank, rods, pistons, etc. 461rwhp makes a good daily driver:nice: http://koolpages.com/potatohell/trucks.html list of mods at the bottom of the page...
  4. L

    supercharger VS. NA motor question

    your mechanic doesnt know much. any type of forced induction will need a tune but there is no constant tuning needed. a lot of people run sc and never have a problem. i have 3 complaints about my sc... 1. i have a v1 so it whines loud at idle so its a dead give away i have a sc 2. hp...
  5. L

    Vortech s-trim 10-12 psi. What spark plug gap

    .035 is good. thats what i run with 10psi of boost
  6. L

    when do you need a transmission cooler???

    i agree with everyone, all auto trans should have one no matter if the trans is stock or not. autos and heat dont mix. get the biggest one you can fit
  7. L

    Help Went to the Dyno Today! 307hp and 325tq

    what fuel pump are you using? did you try running fuel pressure at 42psi and adjusting pulse width? your fuel pump may have had trouble with the high volume and high pressure. i recognise this post from mustangforums.com
  8. L

    car wont start

    fixed it!! talked to my friend last night and he said it sounds like the tfi is still good but having trouble conducting a current. he told me to get some electrical grease and put it on the back off the tfi box and on all the connectors so i did that today. i didnt have the right size...
  9. L

    car wont start

    tried to go to my g/f house today and the car wouldnt start. pulled the wire off the cap that comes from the coil and stuck a spark plug in it. my dad cranked it and there was a nice big spark so i know my coil is working. i then pulled the cap off the dizzy to see if the rotor was spinning. it...
  10. L

    Wheel hop problem

    a stiffer shock and some good upper and lower control arms will help.
  11. L

    Whats the thing below the axle housing called?

    its trash
  12. L

    High Compression and Blower?

    you can run 11:1 cr with a sc if you have the right cam. by that i mean a cam that would bleed off some of that compression out the exhaust. and 270hp with 11:1 is piss poor there is something wrong with your car or your tuner is retarded
  13. L

    To spool, or true posi?

    run a locker. if you stay off the gas going around turns the wheels will spin at different rates but as soon as you give it any throttle the two wheels are locked
  14. L

    using extentions on torque wrench cause headgasket leak

    yes! the final torque should be 70-75ft/lbs
  15. L

    supercharger question part II

    stay away from powerdyne. they arent reliable. id go with the vortech personally but the novi 1000 is another great entry level sc
  16. L

    forced induction

    cheap, reliable, easy to install. and some have carb numbers for people like me who have to pass smog
  17. L

    jet chip

    all off the shelf chips are worthless. just advance your timing a little and that will be pretty much the same as what the chip would have done
  18. L

    Will AC work after removal?

    youd be able to reinstall it. maybe a little work but it will run properly
  19. L

    do u think i will need an adjustable regulator for my combo?

    agreed:nice:
  20. L

    new dyno numbers are in!!

    thanks guys! a list of my mods and lots of pictures are at http://www.koolpages.com/potatohell/trucks.html (scroll down a bit)
Top Bottom
Back
Forums
Menu