Search results

  1. banditmwp

    swapping to a 5-speed...

    remembered one more thing..flywheel :doh:
  2. banditmwp

    swapping to a 5-speed...

    btw I have had the trans out 3 times already so I know the starter is a PITA :bang:
  3. banditmwp

    swapping to a 5-speed...

    Well, it looks like a t-45 swap will be forthcoming since the AODE/4R70W in the wife's 96 coupe is acting up.....AGAIN :bang: Here is a list of what I know I will need for the swap...anything I'm forgetting? Tranny Bellhousing Clutch Set Shifter Shifter Trim Boot Shifter outer boot...
  4. banditmwp

    Subframes Installed

    When I got mine, I had them done at an alignment shop. :shrug: Any shop that can weld is fine, as long as they either 1. use a four post drive-on lift 2. do it from a pit under the car. you want the car to be sitting flat on the wheels when they are installed or else your car may...
  5. banditmwp

    2.2 KB dyno results

    Yeah, I talked to Dave yesterday on another board and he sounds like a schoolgirl after her first kiss! :D Congrats again Tim on the progress! :cheers:
  6. banditmwp

    Deep cat back sound-Which One

    :stupid: SLP didn't pay any attention to the Mustang market before the death of the F-body :bs: , so they can go to hell, in my opinion. Me---> :flame: :( <---SLP
  7. banditmwp

    Deep cat back sound-Which One

    I'd say to try the Borla Stinger catback...jmo :nice:
  8. banditmwp

    Anybody in Alabama running an O/R pipe?

    I run a ProChamber with no probs :nice:
  9. banditmwp

    MM&FF mag...

    I like MM&FF but i like 5.0&SF as well MM&FF = Fun Ford events 5.0&SF = NMRA events Depends on what you want, but they both seem to have a nice balance of cars, events, and tech stuff. :nice:
  10. banditmwp

    MM&FF mag...

    :rolleyes:
  11. banditmwp

    It's raining inside my car!

    My vert leaks from the same place, but I believe it is the seal at the windshield. Unfortunately, the only to to fix it is to have the windshield replaced :(
  12. banditmwp

    Engine making ticking nosie.

    well, if you have found the problem, the method I was going to suggest is useless, but as far as gaskets go, I have actually had the best luck with a plain 'ol Fel-pro exhaust manifold set :scratch: I know it sounds crazy, but the Mr. Gasket copper seals leaked and the fel-pro's have held up...
  13. banditmwp

    Turn signal not working??

    well, i don't know what you had it in the shop for, but most likely it was unrelated :scratch: Possibly a bad switch? I have had that happen
  14. banditmwp

    Guess on performance? Advice for track?

    with a 150 shot for the whole pass, i'm guessing low 11's/high 10's if the traction is there with slicks, i don't think you'd spin horribly launching at 3500, but that's just one of those things you'll have to practice on ;)
  15. banditmwp

    MM&FF mag...

    :worship: Mafia is nationwide! :D
  16. banditmwp

    Does anyone know if this new bbk manifold is any good?

    no, it should be available very soon though...I've heard rave reviews and I think that's the one i'm going to go with when I do the H/C/I :D