Search results

  1. N

    THE LAST TIME I POST IN THIS FORUM

    what is it doing just cranking and not firing?
  2. N

    Turbo swap HELP

    The motor and turbo are out of a 1988 Turbo coupe
  3. N

    best method of installing New Tail light Lenses?

    I just pealed my old ones out and then took a small screw driver and cleaned all the old black sealant out and took the clips off. Then I put the new black tar like sealant and clips on then pushed the lenses on. I filled the top gap of the housing with black RTV just to keep any water that...
  4. N

    Turbo swap HELP

    red wire 11.5 yellow wire no voltage, little resistance i have my notes at my dads house and im at school hes going let me know but i think those were the numbers we got, we did it several times. Now if i had 11.5volts at the yellow that would mean my computer is shot because the computer...
  5. N

    Turbo swap HELP

    For the red/grn wire i re-pined it in the grey distributor harness and then i have a wire 4 inches from the connector, spliced and ran to the coil pack(the red/grn wire is on the left side of the connector at the coil pack) On the removeable harness i cut the 3 red/grn wires that went to the...
  6. N

    Turbo swap HELP

    I would buy his harness but I have the feeling its not the harness and if I buy it and I still have the same problem then im really screwed.
  7. N

    Turbo swap HELP

    if the dizzy is 180 out would it cause the injector pulse to be weak, what about a "weak" coil (if there is such a thing). Bad Injector,(even though I measured the Resistance in each and they would ok). I rechecked my engine to firewall ground strap and it was loose, I tightened it up and...
  8. N

    Cam Question

    thanks for the info!
  9. N

    Cam Question

    When you install a 93 roller cam into a 88 Turbo coupe motor do you have to change the cam timing(do i need to buy an adjustible cam gear)? This is for a 88 turbo coupe motor being swapped into a 93 stang.
  10. N

    Turbo swap HELP

    Anyone have a description or picture of what they did to their top removeable harness for the swap?
  11. N

    Are there lowering springs for 4 cylinder convertibles?

    I bought a set from Eibach for my 4 banger notch, they drop it about 1 1/2 in the front and 1 1/4 in the back it looks good!
  12. N

    Turbo swap HELP

    I had 2 different people help me with the swap on both occations. Can you send me a picture of you removable harness, or a more detailed description of what you did to the top harness. I think that the problem is in that top harness because I have read and re-read the instruction and so has...
  13. N

    Turbo swap HELP

    I just realized that I did not put the capacitor on the red/light grn wire, could this may be my problem?
  14. N

    Turbo swap HELP

    I checked the computer (by putting it in another car it ran fine) I check the Vain Air meter I changed the Baro sensor I changed the TFI I changed the Distributor I changed the Module on the strut tower The only other sensors i need to change are: Air Bypass, TPS, Air Charge Temp, and...
  15. N

    Turbo swap HELP

    I checked each injector plug and the resistance is very low. The circuit cant take the load of one or more than one injector thats when the pulse is extremely weak to no pulse. I keep thinking its a ground problem. What about the main negative battery cable that runs to the bottom of the...
  16. N

    Turbo swap HELP

    How do you ground the injector harness? In stingers swap info there was no instrustion to do so. I grounded pin 49 and the ignition ground (for the distributor) right to the battery. The connections for the case ground and the two main ground wires for the computer were cleaned and checked...
  17. N

    Turbo swap HELP

    I put the 88 turbo coupe throttle body on my car would that cause a weak pulse, or what other sensors would cause a weak spark. The computer and VAM were tested in another car so i know they work.
  18. N

    Turbo swap HELP

    This is the second time that i have done stingers turbo swap and i still have a weak injector pulse. Can someone tell me what wires i need to connect in the removeable part of the harness. I have spark but a weak injector pulse.
  19. N

    What starter should I use 1993 2.3 or 88 2.3 turbo

    After doing the turbo swap which starter should I use on my car or does it matter? Are there any differences???
  20. N

    Cranks but no start after 2.3 turbo swap

    Nope, what color wire do I have to ground for the injector harness is it the orange/red wire that also goes to the ground on the distributor plug. What wire do I ground for the o2 harness. Do I just splice into the wire at pin 49 and run a wire to the ground by the kickpanel in the car...
Top Bottom
Back
Forums
Menu