Search results

  1. warriorpluto

    oil pump?

    no knocking at bottom or up top anymore. but im still going to change it out.
  2. warriorpluto

    oil pump?

    i might go that route. but if i were to buy a stock pick up tube there shouldnt be any reason to adjust it right? even if i were to reuse the stock pick up tube? cause i read somewhere that people had to adjust where the pickup tube sits between the oil pan. and what about the oil pump drive...
  3. warriorpluto

    oil pump?

    already did. a no go. i checked the whole ark-la-miss
  4. warriorpluto

    oil pump?

    when i do a cold start oil pressure stay at 50psi. rev it up past 5000rpms and oil pressure drops to 20 psi. could be the shaft? if i could find a nice running gt40 engine for 300$ i can afford that. no junkyards have 5.0 explorers out here.
  5. warriorpluto

    oil pump?

    this put me in a real bad spot cause i i already have another mustang with a fresh rebuild i cant even get started. money is really tight right now. i just have to gamble on this one. i wont mess with the bearings ill just change the pump and shaft. i have a ford racing hardened shaft. is this...
  6. warriorpluto

    oil pump?

    what if i wanted to just go on ahead and replace the bearings while im in there? how would i do this? it would be my first time messing with the bottom end. i think the bottom end is ok though but if a possibility its not can i just go to parts store and get new bearings? any special tools?
  7. warriorpluto

    oil pump?

    well i have a 90 mustang gt 5 speed. all stock 114,000 original miles. i noticed that when i drove the car previously the oil pressure gauge would jump from the middle mark to below past zero. ok.....everytime i get on it the oil pressure gauge dropped to zero. well today i got on it again to...
  8. warriorpluto

    8LD??

    my car is an 87. it was originally aod but when i bought the car the c6 was already in it. i want to go back with an aod. i just recently swapped a whole 88 cali mass air harness in my car and i have the 8ld. i just dont want to fry the ecu. so i guess i will put the a9p in it.
  9. warriorpluto

    8LD??

    i just did a swap with the same cpu(8ld) but i have a c6 transmission in my car. i also have an a9p laying around. so i need to switch back to the a9p? or could i just get a manual o2 harness?
  10. warriorpluto

    mass air meters

    thanks for the link but if i were to use that would i need a gasket to go in between?
  11. warriorpluto

    mass air meters

    oh ok i got you. is it true you can use the ones from a v6 too?
  12. warriorpluto

    mass air meters

    since i can use a maf from a sn95 can i use the housing too? i also have a cai for a sn95. can i use that and the mass air meter housing on my 87 mustang?
  13. warriorpluto

    crank but no start

    i ave a crank but no start condition. i had my gt40p heads done at a shop they put 600lift limit valve springs on it. i changed my wiring harness. still same problem. everything electrical and on the engine is new. but i think i might have messed up some where. the car dumped fuel in the oil. ok...
  14. warriorpluto

    relay

    how did you guys feed the wiring harness back down through t firewall? whats the easiest way?
  15. warriorpluto

    relay

    o ok thanks alot i guess it really was my harness then. i did an engine swap and i think the injector harness got messed up or something
  16. warriorpluto

    relay

    what is the relay for thats on the passenger side of the motor by strut tower?i had a no start condition on my 87 and i never found out so i decided it was a good time to switch to mass air so i have the whole cali 88 harness. in the process the relay i just mentioned had crud all in it so im...
  17. warriorpluto

    Anyone change the spoiler light?

    what about the ultra bright ones they sell on ebay?
  18. warriorpluto

    Anyone change the spoiler light?

    im going to have to look into this
  19. warriorpluto

    explorer intake vacuum line question

    thanks ill save that diagram this time
  20. warriorpluto

    explorer intake vacuum line question

    anyone have any pictures of how you set yours up?
Top Bottom
Back
Forums
Menu