Search results

  1. T

    96 - 02 Engine Swap Complete: Pics + Vid

    I'd like to do this swap too. I'd be nice to swap in a nice low mileage PI engine in a year or so. Nice car! :nice:
  2. T

    Lifters for my 331

    A lot of people say roller lifters when they are talking about hydraulic roller lifters. When people start talking about roller lifters for a mechanical roller cam they tend to specify mechanical roller lifters.
  3. T

    351w block

    I think all roller cam 351W's are F4TE blocks That's a '94 truck engineering number. Any 351 block will work. Pre-70 deck height is 9.480". Post-70 deck height is 9.502". Both per FRPP catalog. I have read in more than one publication that all 351W blocks are the same structurally as...
  4. T

    opinions on my setup

    Only thing I see is you need 3.73 gears (esp w/ that cam & it's powerband). Otherwise I bet it runs strong.
  5. T

    9" rearend swap for 91 gt

    At Moser you can buy a bare housing with all the brackets for the fox Mustang for $510
  6. T

    frpp superchager?

    I like the FRPP blower a lot for a daily driver. 6 spi is just enough to give a healthy low end boost in torque, which ALL 4.6's need desperately IMO. I have an old Super Ford at home with a before and after dyno and install article on the FRPP blower on a '97 (I think). Not bad at all for...
  7. T

    9" rearend swap for 91 gt

    I contacted Moser once about narrowing and adding brackets to my supplied housing in addtion to making a pair of axles and they flattly told me they would not do that and I would have to buy a complete axle housing from them.
  8. T

    Car shuts off at 98!!!!!

    Back to the original post. Another possibility is the 103mph could also be the speed measured on the track, while the 98 mph mentioned is the speed displayed on the speedometer. We all know how "accurate" the factory guages are.
  9. T

    Car shuts off at 98!!!!!

    And I'm trying to figure out WTF is going on with my car?!?!? You can't argue with physics yet my car seems to do the impossible. So something else is going on. :scratch:
  10. T

    Car shuts off at 98!!!!!

    Then explain what other forces are causing the car to continue to gain some speed. Everyone is quick to discount my ideas, but no one has offered any other explainations. :shrug:
  11. T

    widest tire on 17x9

    IMO a 9" wheel is pefect for a 275 width tire. A 17x9, for example, needs a 275/40R17 IMO. It also happens to be pretty much the same height as the 245/45R17 that came from the factory. So no changes are needed for the speedometer.
  12. T

    Car shuts off at 98!!!!!

    Well I say again.... Then please explain to me how my car continues to gain speed even after I have removed engine forces by depressing my clutch, disconecting forward motion providing power. When I push the clutch in at 70 mph while accelerating hard, the car continues to gain some speed...
  13. T

    Car shuts off at 98!!!!!

    Ummm yes, it will. I'm done with this as it is a waste of my time.
  14. T

    9" rearend swap for 91 gt

    No other Fords will interchange directly. Call Moser Engineering (or any other axle specialst) and order the housing/axle package from them and add the parts (3rd member and brakes) from a donor 9" you can get locally. Oh and you will need a different (shorter I believe) drive shaft too.
  15. T

    Car shuts off at 98!!!!!

    Take a 10" diameter 1" thick "wheel" of steel. Accerate it at a constantly rising rate and then abruptly take away the accelerating force. For a short time the wheel will continue to accerate due to it's mass.
  16. T

    Car shuts off at 98!!!!!

    It sounds as if what you are proposing is that if I floor my car and run it up to say 80 mph and let of it will immediatly stop accelerating at that speed and not go one bit faster. Or if I get to that speed and push the clutch in it will immediatly start to slow down. That is absurd and I...
  17. T

    Car shuts off at 98!!!!!

    Actually this ability to continue gaining speed even after letting off is enhanced with an automatic. They, by design, store energy in the fliud within them and then distribute that energy in, for lack of a better term, a smoother way. Ever hit the gas in grandma's car and nothing happen's for...
  18. T

    Car shuts off at 98!!!!!

    Then please explain to me how my car continues to gain speed even after I have removed engine forces by depressing my clutch, disconecting forward motion providing power. When I push the clutch in at 70 mph while accelerating hard, the car continues to gain speed, all be it at a slower and...
  19. T

    Off The Line Power

    Sounds like you're looking for torque. Gears will help get into the torque you have quicker and increase the multiplication of that available torque. But to truely get a lot of low end torque you will need some sort of positive displacement supercharger. Like a Kenne Bell or Saleen or...
  20. T

    Ive bitten my tongue long enough

    Prochamber, Power Chamber, what ever the name it works! :D
Top Bottom
Back
Forums
Menu