Search results

  1. dagenham

    high beam indicator light

    When I unplug both headlight bulbs the indicator light works properly. But even with just one bulb plugged in(and it doesnt matter which one) the light stays on either way. Does anyone know which wire is wich on the plugs for the headlight pigtail?? I am thinking that I may have crossed a wire...
  2. dagenham

    high beam indicator light

    No, I pulled the socket out and checked it individualy and it is always lit.
  3. dagenham

    high beam indicator light

    The little red dot for the high beam indicator in my '66 mustang is always on when the headlights are on. It gets brighter when I turn the lights up on high beam but when I turn the lights down on low beam the indicator light is still lit but dimmer. Could I have a problem with my headlight...
  4. dagenham

    A4LD to C4 swap

    Has anyone here swapped out their A4LD for a C4? My brother in law would like to swap out in a '93 2.3. I told him I dont know if it would work because of the electronics involved. Anyone have any other insight to this question??
  5. dagenham

    monte carlo bar size

    Thanks for the info guys. I think I took a measurement and only got 39 inches. Yet the shock towers are really solid.
  6. dagenham

    monte carlo bar size

    I need some help confirming what I am suspecting. Can someone give me a measurement of how wide their monte carlo bar is in a '67 or '68 coupe?? I think my shock towers have moved inward but am not sure.
  7. dagenham

    e-brake routing

    I am getting to the end of a 5 lug cobra swap on my wife's '91 LX. I got the FRPP front e-brake cable and the SSBC rear cables. Now my question to all of you guys that have done this swap is how and where did you mount the rear cables to car to keep them up and out of the way without kinking...
  8. dagenham

    anyone have any nice/built SVO's?

    Apparently you do not kno about the SVO Club of America. Take a look at their website and I think you will change your mind. Mustang SVO Website Sponsored by the SVO Club of America
  9. dagenham

    Headliner Installations Stink!

    If the adhesive you were using was not holding then something was not right. I hope that doesnt come back to bite you later down the line. I've never had wrinkles come out by just letting a car sit out in the sun. Trust me a hair dryer makes the minimum amount of heat needed to take wrinkles...
  10. dagenham

    SN95 Rear Swap E-brake setup ??

    I am at the end of doing the cobra brake swap and have gotten to the e-brake cable. I tried to order the parts from Ford racing and was told the rear cables are no longer available. Called Late Model resto and ordered all 3 cables from them. They still have the front cable from Ford racing but...
  11. dagenham

    Brakes help please

    Hey guys, I dont mean to hijack this thread but I have one question about the swap. What did you do for the E-brake cables??? I am doing the whole swap right now and I am almost to the point of finishing up and the cables are the last thing I will have to do.
  12. dagenham

    hatch cover

    I just found this thread thru the forum search because of the same fitment issues. I have a '84, '88, and '91 to measure, and all three are completely different in length. Ford and their better ideas:rolleyes:
  13. dagenham

    conversion question

    There is an awful lot of stuff to change to do the job right. Brakes, fuel pump, electronics(if you keep it fuel injected) front springs, probably the entire rear axle if it only has a 7.5, engine mounts(dah). Etc. For all the trouble it is to truely do the job right in my eyes it is worth...
  14. dagenham

    Voltage Jumping Around - Signals Blinking Slow

    The alternator also has an internal voltage regulator that could be going bad. JMTC
  15. dagenham

    84 5.0 battery being drained. help?

    First of all how long does it take to drain the battery?? A day, a week? If you dont have a multi meter you can just use a test light. I had a burned out taillight bulb actually give me a dead short and drained a brand new battery overnight.
  16. dagenham

    '82 to '89 Dash Swap, need experience

    I have never swapped from one to the other but I have an '88 and an '84. I am sure the heater boxes will be different. I have had the dash out of the '88 but not the '84, but have had the dash pad out of the '84 and been under it. I am sure there are going to be a couple braces that are going to...
  17. dagenham

    Complete floor assembly (full floor pan all the way to the trunk)

    I would tack weld a brace from the rear of the left door jamb to the front of the right door jamb and from the front of the left door jamb to the rear of the right door jamb creating a big X brace. With this brace in place the car cant twist, spread apart or come together. As long as the roof...
  18. dagenham

    Spent some time researching the water pump rotation saga…

    The dipstick hole and opening for the mechanical fuel pump are the only differences. The holes for the cooling are all the same.
  19. dagenham

    93 Cobra brake booster install

    I have not done this job yet but when I asked a guy with a very nice fox body show car he said he drilled a small hole in the strut tower and pulled it from the outside with a slide hammer. I guess if you dont want to drill another hole you could weld a piece of something on the tower and and...
  20. dagenham

    Patch Material - need suggestions

    The cracks at the top of the a-pillar and also if it is a coupe in the lower rear corner of the quarter window are typical Mustang problems. The subframe connectors are a good idea. Two other pieces you can add is the monte carlo bar that goes between the shock towers and an export brace that...
Top Bottom
Back
Forums
Menu