Search results

  1. R

    Running Hot after new TFS intake install???

    yes the hose is hot and yes i tried a new tstat????
  2. R

    Running Hot after new TFS intake install???

    So I should drain out then start from scratch???
  3. R

    Running Hot after new TFS intake install???

    There is a bleeder valve on the top of the t-stat... If there is air in there how will that make it get hot? I backed down my driveway and ran it till it got hot and overflowed then filled it up again and again would that not have gotten all of the air out?
  4. R

    Running Hot after new TFS intake install???

    If I just drain it all then refill will that work? Is the thermostat in correctly if the spring is facing the engine?
  5. R

    Running Hot after new TFS intake install???

    I have ran it with the cap off until it heats up and overflows then I make sure and keep adding water? If someone knows the best way let me know. Before the intake swap it ran nice and cool.
  6. R

    Running Hot after new TFS intake install???

    I put it in like the haynes manual said with the spring toward the manifold...? Is that the correct way? It is getting air bubbles also? I don't know what the next step is?
  7. R

    Running Hot after new TFS intake install???

    Hey Guys I just put on a new Trick Flow Track Heat intake and replaced the temperature sending unit on the lower, put a new thermostat in and a new radiator cap. Filled it with coolant and now it is running almost to the last notch. I have a new radiator a new electric fan, new hoses??? It...
  8. R

    Codes 41 and 56 what can I do??????

    I have codes 41 and 56 popping up and I wonder what I need to do to fix this??? HELP!
  9. R

    oil pan drain plug stripped!!!

    The butterfly plug is starting to dry rot and they say it is only good for a few oil changes...
  10. R

    oil pan drain plug stripped!!!

    I think that might be my only option... I hope I can find a tap big enough? Any tips or tricks would be appreciated.
  11. R

    oil pan drain plug stripped!!!

    I guess whoever had the car before me stripped out the plug then went to an oversized plug. It is now stripped and I have a temporary rubber butterfly plug in there. What is the easiest way to fix this without raising the engine and pulling the pan??? I really want to get out of this with a...
  12. R

    timing issue?

    I pulled the following codes with the engine off 14 18 29 66 I read what each one means but I dont know where to go from here?
  13. R

    timing issue?

    It doesnt tell me how to perform that test?
  14. R

    timing issue?

    Hey guys I have a 90 lx 5.0 that when I drive it cuts out so I checked my timing and it jumps around between 10 and 20 degrees, the distributor is locked down and doesn't move, I replaced the ignition module and I have a new blaster 2 coil and msd cap and rotor, new plugs and wires, and a new...
  15. R

    HELP! bad vibration

    Not at all I am positive on that one...
  16. R

    HELP! bad vibration

    Yes I did just have new gears put in with a master bearing kit... But it seams like if that were the problem then it would vibe all the time or howl???
  17. R

    HELP! bad vibration

    Well I turned the driveshaft, replaced the u-joints, took it to another place to check the balance on the tires???? I cant figure it out. Any help would be great
  18. R

    Turn Signals, backup lights and blower moter

    Thats exactly what it was... I put a new one in and not a problem at all...
  19. R

    HELP! bad vibration

    I think it could be the way the driveshaft is bolted to the flange at the rear end??? Does this make sense?
  20. R

    Turn Signals, backup lights and blower moter

    I am getting no power to the fuses on these items??? I have read that they are all tied to the same fuse link any ideas where I can find this?
Top Bottom
Back
Forums
Menu