Search results

  1. spdfrkaby

    clunk from front end while backing up with steering cranked all the way...

    sounds like a tie rod to me also. I had a tear in the boot which caused all the grease to come out so it was metal on metal.
  2. spdfrkaby

    clunk from front end while backing up with steering cranked all the way...

    sounds like a tie rod to me. On mine everything looked fine but there was a tear in the boot which caused all the grease to come out so it was metal on metal.
  3. spdfrkaby

    18x10's

    295x35x18 BFG KDW2's, best tire I've been on so far. I've had 555's and Kuhmo's.
  4. spdfrkaby

    Widest tire up front?

    On mine a 275 will rub at full turn with a steeda sway bar. I have 255's with a 1" spacer and it rubs just a little bit too a full turn. It's sticks out a little bit but needed to in order for the Brembo's to fit.
  5. spdfrkaby

    Wheel Spacers

    Ditto, I have a 1" spacer on the front end so I could fit the Brembos. I'm putting 1" spacers on the back too once I get back to the US. I've driven almost daily above 100mph on the autobahn until today since it started snowing with no problems. Had them on for about 4 months now.
  6. spdfrkaby

    Tranny grinds sometimes during downshift...clutch or tranny???

    Yeah it grinds in cold and warm weather. I just hit 40K on mine. I've never dealt with the tranny in any way. Is the syncro something that could be done by myself and if not how much would something like this cost?
  7. spdfrkaby

    Tranny grinds sometimes during downshift...clutch or tranny???

    Yeah, it does it at low rpm downshifts, say like when your pulling up to a red light and you downshift to engine brake.
  8. spdfrkaby

    Tranny grinds sometimes during downshift...clutch or tranny???

    This has been a problem for quite some while but didn't think too much of it since it wasn't that major, it's just an annoyance now. Only thing aftermarket dealing with the tranny is a short throw shifter. Stock clutch and flywheel. When I'm downshifting through the gears mainly from 3rd to...
  9. spdfrkaby

    Xmas Supercharger

    To get something in that price range your going to have to search the classifieds on all mustangs forums and ebay. I found my Procharger P1SC with a 2 core intercooler, 42lb injectors and a 90MM lighting MAF sensor for 1800 on one of the Mustang forum classifieds.
  10. spdfrkaby

    New Bumper??? which one To Get

    Disagree on staying away from the Cobra bumper. As long as you don't start putting on Cobra badges you're ok.
  11. spdfrkaby

    New Bumper??? which one To Get

  12. spdfrkaby

    Which Tires?? Need Today!

    second the KDW2's.
  13. spdfrkaby

    Tires and Springs - Need Suggestions

    The 555's lost grip a lot sooner than the KDW's. I have the TA2's on. I've had the KDW's on for about two months now and it seems like a normal wear tire compared to other high performance tires.
  14. spdfrkaby

    Tires and Springs - Need Suggestions

    Here's a pic of KDW 295's on a 10" rim. These tires grip very well in dry and wet road conditions. Had 555's on before and the KDW are much better. Sorry, but I don't have a good shot of just the rear tire. Here's a pic of the stance with Eibach springs. Had BBK springs before and...
  15. spdfrkaby

    Which stage Mcleod for ProCharger and future shortblock???

    Ok now that I've decided on what and where to buy the clutch and flywheel, I have another question. I will be putting a ProCharger in which will be pushing about 400hp then in about a year I will be doing the shortblock (around 500-550hp). Question is which stage clutch 1-4 should I get and does...
  16. spdfrkaby

    Best place to order McLeod clutch and Fidanza aluminum flywheel?

    Ok now that I've decided on what and where to buy the clutch and flywheel, I have another question. I will be putting a ProCharger in which will be pushing about 400hp then in about a year I will be doing the shortblock (around 500-550hp). Question is which stage clutch 1-4 should I get and...
  17. spdfrkaby

    Best place to order McLeod clutch and Fidanza aluminum flywheel?

    Thanks DragonII
  18. spdfrkaby

    Car dies for some reson after WOT.

    Also check the MAF sensor. Need a special tool to get to it and use electrical wire cleaner on it.
  19. spdfrkaby

    Best place to order McLeod clutch and Fidanza aluminum flywheel?

    Been doing some research on the best setup since I'm about to install the ProCharger. Figured out what I wanted but now I need to know where the best price for these are at. Thanks in advance and if anyone has any other better options/combo's I'll take that too.
  20. spdfrkaby

    nice little mod I thought I'd share. (LED license light)

    Had a Civic before my last two 2000 Mustang GT's. It was sqooshed at 5 mph. No more cracker jack toys for me.
Top Bottom
Back
Forums
Menu