Search results

  1. larrym1961

    Strange No Start Condition

    Motorcraft DY1284 TFI's are junk made in China. I had a MSD TFI last longer than a DY1284 if you can believe that.
  2. larrym1961

    Question On A Ford Obd-1 Code Reader

    I have a Innova digital Ford code reader. to erase codes on it. After the test is done for codes and they are retrieved. You re test, hit the Test/hold button then when the test begins hit the test/hold button again and codes are erased.
  3. larrym1961

    Whining Sound In Bellhousing Area

    I thought about a new clutch when I had Trans out but never even looked at it because it was still working and grabbing great. Originally thought the whine was coming from a bad main shaft bearing because my trans had been ran low on fluid. Anyway it's a Ford Racing King Cobra installed in 2005...
  4. larrym1961

    Whining Sound In Bellhousing Area

    I have a supercharger type whining sound coming from the bellhousing area. Transmission has new main shaft bearings in it both front and rear and I also have a new throwout bearing. But this noise also was going on before I had the Trans Main shaft bearings and throwout bearing replaced. The...
  5. larrym1961

    Got The Latest Mm&ff

    Posted on Fox Body Addicts
  6. larrym1961

    Pip Code 14 After Remote Tfi Install

    UPDATE: I did some research and found that a faulty TFI will also throw this code. So I took out the new "so called" Motorcraft TFI and replaced with the original Motorcraft TFI my Mustang came with in 1987 and car starts, stays running and throws no more code 14. It sucks that every TFI out...
  7. larrym1961

    Pip Code 14 After Remote Tfi Install

    I just installed a Remote TFI on my Mustang. I also installed with the remote TFI a new Motorcraft DY1284 TFI Module. After running the car for about 5 min it died and had a hard time starting again. So I ran codes and got code 14, PIP Sensor failure. Could the installation of the remote TFI...
  8. larrym1961

    Source For Genuine Ford Or Motorcraft Parts?

    NPD Motorcraft TFI's are out of stock. LMRS have just recently stocked Motorcraft TFI's. I just bought one off eBay myself.
  9. larrym1961

    Fr King Cobra Clutch, Keep, Replace Or Upgrade?

    The price for the McLeod Street Pro clutch is a pretty decent price from LMRS, $263.20 compared to over $300 that Summit Racing wants for them. LMRS lists this clutch on their stage 2 High Performance list along with the RAM Powergrip clutch.
  10. larrym1961

    Fr King Cobra Clutch, Keep, Replace Or Upgrade?

    I have heard good and bad things about RAM Clutches and probably more positive than negative things on the King Cobra. A lot seem to like the Centerforce too. I am debating on if I do replace my present clutch with possibly going with the new McLeod Street Pro clutch. Anyone using one of these??
  11. larrym1961

    Fr King Cobra Clutch, Keep, Replace Or Upgrade?

    Since I have a McLeod SFI steel belhousing I have a few extra bolts to undo to get to clutch. I'll have to pull that off to inspect the clutch.
  12. larrym1961

    Fr King Cobra Clutch, Keep, Replace Or Upgrade?

    I have my Tremec 3550 out a little repair. I ran it low on fluid and overheated the main shaft bearing now it whines like a supercharger. Since my car has long tube headers and everyone knows what a bitch a clutch swap can be with these in place. I am wondering. I have less than 20,000 miles on...
  13. larrym1961

    Where To Buy Genuine Motocraft Tfi Modules?

    Rockauto.com has 1 Motorcraft TFI left for $107
  14. larrym1961

    Electrical Aod-t5, Speed Density To Mass Air, 02 Harness Differences, Etc

    Mine has no loop as shown. Probably a reason I can run this set up with an A9L and not burn a trace on the ECM with an improper looped O2 Harness. My car has a Moates Quarterhorse tune on it and runs great.
  15. larrym1961

    Electrical Aod-t5, Speed Density To Mass Air, 02 Harness Differences, Etc

    I have a 87 that I have done both a Mass Air swap and a AOD to Tremec 5 speed swap. I have done all the 5 speed trans harness swaps you have mentioned, but the factory O2 Harness remains in place. My question is, if my 02's were not functioning properly wouldn't there be a code present for it??
  16. larrym1961

    Tremec 3550 Whine

    I am willing to bet it's the bearing race as U mentioned. We did an aggressive Moates tune on it and that is when the noise started. That was when I did the switch from the ATF to the Syncromesh and there was not much old ATF that came out when I drained it. So the bearings must have overheated...
  17. larrym1961

    Tremec 3550 Whine

    I used the black of course. I believe I paid $8 a quart for it
  18. larrym1961

    Tremec 3550 Whine

    Recently I went from Dexron III ATF to Syncromesh Trans fluid in my 3550. It has since developed a whine that almost sounds like a supercharger or gear drive to it. It still sifts and works just fine. Do I have a cause for concern?
  19. larrym1961

    Bama Drama

    I had one of their 4 Bank Eliminator chips. When it was switched to the Anti Theft mode, the fuel pump would run constantly but not in any of the other settings. It's possible yours is in anti theft mode? now I have a Moates chip tuned with a Moates Quarterhorse. Best tuned chip I have ever had...
  20. larrym1961

    Who Has Dumped A Mail Order Tune For A Moates Quarterhorse Tune, What Did You Think?

    I just recently dumped a SCT Eliminator Chip done by Bama @ American Muscle for a Moates Quarterhorse Tune done by Danny Baird @ Baird Racing Engines. And I tell you what a change that was. Can't wait to see what my gas mileage is after the new Moates tune. With the SCT I was getting a whopping...
Top Bottom
Back
Forums
Menu