Search results

  1. Chrome_Rust

    What do you think? SN95 Dash 93 Notch

    handles are trimmed to open...
  2. Chrome_Rust

    What do you think? SN95 Dash 93 Notch

    It's still a project car, everything works, Cruise, A/C, drives well, and I love it. Still contemplating a color choice. What do you think? Right now it is a daily driver again. The fuel pump took a crap in my Olds Intrigue. Swapped on some 15" BFG Extenia tires and a 50lb bag of kitty...
  3. Chrome_Rust

    car likes to hesitate under throttle in 3rd and 4th.

    Check all of your grounds. its a start.
  4. Chrome_Rust

    Mechanical oil gauge feed line, is this the best?

    Same here... through the Speedo cable hole. I did a 01 dash swap and have VSS signal for my speedo... why don't you have a cable?
  5. Chrome_Rust

    Will a stockish 289 take it in the 10s.

    It might. With tons of boost and a huge sniff of giggle gas....
  6. Chrome_Rust

    I want some billet HVAC knobs for my 91

    Hell I have a set of chrome ones I'd give you....
  7. Chrome_Rust

    Keep factory speakers or replace with these?

    You would have to modify the speakerbox under the rear shelf package tray. Plus you would get no high frequencies sent to them. I am assuming that you have the MACH460 stereo. Ford went to an 8 speaker design with the 460 stereo. It consists of 4 1.5" "tweeters" running off the Deck with only...
  8. Chrome_Rust

    4.6 swap into 5.0 car questions

    You will need to swap everything to make it all work with no problems. There is some major changes in the wiring between the years. To make it easy just swap it all out, then if something goes wrong, you know there isn't a wiring issue. But to answer your question, if you swap to a pre 99...
  9. Chrome_Rust

    Cam and spring kit for GT40's or just springs

    I have a VERY simular setup. I went with a Ford Racing Spring, Ford Racing M-6513-A50 Ford Racing Valve Springs and an E-303. You can leave the stock cam if you wish, and you might be happy with the performance, but since you are almost down that far might as well swap them out, toss a timing...
  10. Chrome_Rust

    5-lug MC Question

    I just gutted the brake lines on my car and ran new. I have a 95V6 MC, 01 front calipers, 86SVO rears. front brakes are T'd together, going to the rear port on the MC, rear brakes are T'd together going to the Front through a Wilwood Prop valve. car stops NOW. Just trying to give you another...
  11. Chrome_Rust

    explorer intake throttle body ?

    I would run the explorer 65mm TB. I have that on my 302 and it is more then adequate (sic?) to feed my engine. You will need to swap throttle arms but that is it. I also machined out my EGR spacer to 65mm to take advantage of the TB. Unless you have a serious engine you will not need anymore...
  12. Chrome_Rust

    Valve cover value question....

    just put a set of 93 cobra covers on my car. total on ebay with shipping was 47 (probably the ones cjrpony is talking about)....
  13. Chrome_Rust

    Well, what is your winter project this year?

    If you want I can come take that POS TKO from you. I'll even lift it for you, that way you don't have to lift it and strain your back.... :D
  14. Chrome_Rust

    Well, what is your winter project this year?

    Get the engine back together, again.. mach 1000 amp and sub install to augment the mach 460 in there now, Cobra front brakes, New 94-97 Cobra wheels, Fix the sagging headliner, New black sunvisors, 99-04 rear seat to match the fronts, new A/C compressor, Install the V8 Cruise modulator so I can...
  15. Chrome_Rust

    loss of boost after rebuild!!

    Well posting in all caps is not going to get you anywhere, use some proper etiquette... We'll just leave it as you forgot caps lock was stuck on... Moving on, Upgrade to the V1 Si. There, done.
  16. Chrome_Rust

    loss of boost after rebuild!!

    Boost is nothing more then a measure of restriction through an engine. If you allow more air to pass through the engine unboosted the ammount of restriction that the engine will see will be less, hence lower boost numbers. On an E7 head the exhaust is the major restriction. Since you cleaned...
  17. Chrome_Rust

    Anybody have a good stereo system?

    Swapped in the mach460 in my 93. Since I swapped the dash, i lost the front tweeter location. So i moved the tweeters from my 6.5 diamond audio component set to the a-pillar. So I have the Mach 460 head unit (6-disc), the rear shelf speakers/amp rack and a decent component set in the front...
  18. Chrome_Rust

    Mustang 5.0 Parts

    Interested in the cam, what would it be shipped to 45840
  19. Chrome_Rust

    Runs great cold

    What is your fuel pressure? I had a simular problem with a 95GT that i was working on. Turns out that it was a restriction in the return line. It would climb to 70+psi and the car would act just like your symptoms. It is worth a shot.
  20. Chrome_Rust

    I know, I know.... Another "Waddya think it'll Make" Thread...

    the e-cam with 1.7's is only .529 lift. I had the same parts on my ported E7 headed engine and i had no issues. I was thinking keeping the stock cam just because I have heard many good things about leaving it there and adding rockers. Since i am looking for driveability more then anything else...
Top Bottom
Back
Forums
Menu