Search results

  1. Nutty 5.o

    Map Light Removal

    Sorry I missed this or could have answered about the clips. I'd check that you first have power going to the one wire that powers it. Next would be to ask if you checked that you have a good ground. Lastly, check the bulb isngood and that the terminals are clean that the screws contact are ok...
  2. Nutty 5.o

    Drivetrain Clutch Fork Pivot: Lock Washer?

    As an update, after a lot of searching, apparently there IS supposed to be this lock washer there.
  3. Nutty 5.o

    Progress Thread 1990 Lx 5.0 Dark Titanium "one Last Ride"

    New set up installed. I did find an answer that there is supposed to be a lock washer under the fork stud in the bell housing. New rear main; went with the Ford Racing. ARP flywheels bolts and FR pressure plate bolt/dowel kit. New pilot bearing installed as well so with a new trans, this...
  4. Nutty 5.o

    Drivetrain Clutch Fork Pivot: Lock Washer?

    Thanks. I'm guessing it won't hurt but was hoping there was more comments on this.
  5. Nutty 5.o

    Drivetrain Clutch Fork Pivot: Lock Washer?

    Replacing my clutch and got a new clutch fork and pivot ball. It had a lock washer under the pivot ball. I don't recall there supposed to one being there. Can anyone confirm which is right as I'm concerned if screwing up the pedal feel Dir to added length, etc.
  6. Nutty 5.o

    Progress Thread 1990 Lx 5.0 Dark Titanium "one Last Ride"

    Yesterday was the day I finally decided to start the clutch job. No problems or suprises and not even any smoking guns of anything wrong. TOB has an issue, but other than that, the rest looks ok. I'm hoping I will find the clutch easier to operate after all this work. The trans was rebuilt by...
  7. Nutty 5.o

    Negative Battery Cable Question

    If it drives you nuts, you can get the Ford negative ground cable from RA for $24.79 assuming you have that mating connection. https://www.rockauto.com/en/moreinfo.php?pk=381681&cc=1133985
  8. Nutty 5.o

    Progress Thread 1990 Lx 5.0 Dark Titanium "one Last Ride"

    Not bad for a ghetto tape measure job, huh?! Yes thanks brother. Much better.
  9. Nutty 5.o

    Progress Thread 1990 Lx 5.0 Dark Titanium "one Last Ride"

    Thanks! I'm sure it will be helpful. If the car stays with me until the winter, I'll be putting the A/C back then. On a side note I got the car back from alignment today. Worlds better!! And the new PS pump and lines aren't leaking as a plus. Specs:
  10. Nutty 5.o

    Classic Insurance

    I went with Grundy on mine. Minimum $10k coverage for under $200 a year. There's some limitations but way cheaper than the other quotes I got.
  11. Nutty 5.o

    Progress Thread 1990 Lx 5.0 Dark Titanium "one Last Ride"

    Also, on a side note, my AC compressor harness is missing. I know I can get a new one. Does it attach to one of the harnesses by the battery? Going off of memory since I don't have a car to check/compare.
  12. Nutty 5.o

    Progress Thread 1990 Lx 5.0 Dark Titanium "one Last Ride"

    It was a nice day in SE Pa Saturday so I tackled the badly leaking PS pump with supply and return line swap. I also spent more time than I should have cleaning up the old ran so I could make sure I would know if there's any more leaks. Some before pics and during. Tomorrow is the alignment so...
  13. Nutty 5.o

    Fox Raising Rear Of Foxbody

    Yes the isolators should be on the top and bottoms. I know some have taken one out to add some extra drop but I wouldn't recommend that.
  14. Nutty 5.o

    Progress Thread 1990 Lx 5.0 Dark Titanium "one Last Ride"

    Finally did the 92/92 dome light install. Not really a big deal, but much preferred and isn't completely a plug and play swap. I really wish I took some pictures, but this is what is needed: Need to run a full time power source (I tapped off the sun visor mirror feed) to the dome light. This...
  15. Nutty 5.o

    Progress Thread 1990 Lx 5.0 Dark Titanium "one Last Ride"

    Finally have an alignment appointment set up for next Tuesday. I ended up putting a bump steer kit on and put in the poly front spring isolators in as it still has the original rubber barely there. Rack boots were leaking so it was a good excuse to swap these out. Pics without the end links...
  16. Nutty 5.o

    Build Thread 1978 Mercury Cyclone. The pig is in the pen.

    I feel your pain. Well not literally yet since you didn't have this done but I respect your decision. It's ok to be scared. Don't have the knee issues but totally unrelated have the knee (and joint) pain. Hang in there! Having a good friend go this he's happy he did it. It will be well worth it...
  17. Nutty 5.o

    Mustang5l5's Progress Thread - Archived Progress thread '08-'20.

    Not crazy at all! I think it looks awesome on the wall.
  18. Nutty 5.o

    Progress Thread B4d Lx

    BAD ASS! Pretty cool to see something that seems really not that common to see over there!