Search results

  1. 4

    need to keep going

    ive already had it in and running , heres a pic
  2. 4

    need to keep going

    what kind of hp we talking if i cant get to 350 then there is no point to finish
  3. 4

    need to keep going

    should i keep going im new to the 4.6 engine. what i did was put one in my 90 rx7 vert. after weight reduction and the motor i hope to be at 2800 - 3000 lbs. i used the aode trans and have 4.10 gears. i had planned on shorty headers ,intake , plenum ,75mm tb, and spacer, 80 mm maf underdrive...
  4. 4

    can someone please help

    95 crown vic dont have the chip in the key so no pats the setup is return but i set it up returnless by looping the rail with a t
  5. 4

    can someone please help

    im also using the crown vic ecu and the pump puts out 80 psi i had the fuel rail looped to one line could it be because the presure was so hi instead of 40 psi
  6. 4

    can someone please help

    i used a 95 crown vic pi harness
  7. 4

    can someone please help

    i have put a 4.6 in my mazda rx7 the coils fire. but it wont start if i run gas through the throttle body it will run. any ideas why the injectors wont pulse? i need any help
  8. 4

    obd2 dlc

    can no one help
  9. 4

    obd2 dlc

    iput a 4.6 pi in my rx7 wiring is done except the dlc i need to know how to wire it i have the hot and ground and the 3 wires to the ecu but i dont know where the other 2 wires go if i even need them to run codes someone please help me thanks
  10. 4

    data link help

    i am putting a 4.6 pi in my 90 rx7 wiring is done but for the data link i know all the wires but but 2 of them are for a module that goes to several diferent modules is there anyway to use it with out the module i just need to test engine componets may be use a obd1 conector thanks for any help
  11. 4

    wiring help

    i have a 4.6 pi in a rx7 most of the wiring ive figured out by shop manual but its not thoughout could someone tell me where to get a bettr printout or help me with the wires in the plug where some of the engine harness goes into the body any help would be great thanks
View older results
Top Bottom
Back
Forums
Menu