Search results

  1. GTblack_00

    Tach gauge "sticking."

    thinking about it. sounds like a gage issue or harness at the rear of them.
  2. GTblack_00

    Tach gauge "sticking."

    Your engine wouldnt run, the r's are calculated by a trigger wheel on the crank which runs the ignition.
  3. GTblack_00

    Tach gauge "sticking."

    unfortunatly it sounds like the servo back there is going bad, the sensor part of it anyways. If your car is running fine then it is somewhere between your computer and gages or the gage itself.
  4. GTblack_00

    Why wouldnt my car start this morning?

    its called PATS II Every once in a while the code wont catch from your key.
  5. GTblack_00

    original battery life

    Theese are wet lead acid batteries!!! They are workhorses and good for about 8-10yrs untill they get the first run into the ground, then they are trash. Some are better than others, but should not die easy unless you let them discharge more then 50-60% frequently A great replacement is an...
  6. GTblack_00

    OBD-II TPS Sensor issue?

    Your readings should be 19.4 to 19.6% at closed throttle and damn near 100 on open throttle, loosen the screw drill out holes and align correctly. stock closed should be .97-.98v = 19.4-19.6% reading goes from 0-5v.
  7. GTblack_00

    CEL Code Not Right? Symptoms dont match?

    how old are you o2's ?? might not be working correctly anymore, also take off fmu and have it dyno tuned, check for maf contamination(filter oil).
  8. GTblack_00

    5.4 engine questions

    the block has a .8x higher deck height, intake has to be .8x wider, also navi heads flow almost the same but have a larger intake port to support the stroked condition the 5.4 presents as they were originally designed and optimized for 3.7 stroke not 4.1x.
  9. GTblack_00

    Starting car after 3 weeks of sitting

    OIL CIRCULATION simply hold down the gas pedal all the way and crank it for 10-15 seconds and the stop, let go of gas and then start her up. The eec automatically does a fuel cut when you hold down the gas all the way durring cranking, this will get your oil circulating b4 you start her up.
  10. GTblack_00

    Bassani SUCKS!!! do not buy!

    Wow, Mil Elims and dont forget to tell the dealer to go F@#$ them selves next time. $90 FOR A 2 MIN SCAN!!!!
  11. GTblack_00

    Guys with 4.10's

    Any car I have ever done gears on has been less noisy or had less apparent noise than factory. Heat cycles are very important, you can bake the oil if you drive without heat cycles durring break-in. You'll be driving with some worn lube in the rear unless you did the proper heat cycles. As...
  12. GTblack_00

    Problem solved for 5.4 intake?? turbo setup.

    Ive got the motor pretty much done, its what is in my sig, the motor is in my car and I drive it around. I was pretty much just looking for an intake I could use to hold boost and this one also simplifies cooling the air charge. With stock heads I can easily get 600rwhp with the 2 turbos...
  13. GTblack_00

    Problem solved for 5.4 intake?? turbo setup.

    I just had a great Idea float right by... Anyways I want to have a air-water intercooled twin turbo setup, soo. A lightning lower intake and intercooler with a custom intake plate!! ? What do you think??
  14. GTblack_00

    Turbo cam specs? and where from??

    I am looking to run about 14-20 lbs of pure pleasure and I will buy these cams from Tim. I just want the most from my boost!! I am going to have the cams installed with the turbos, hopefully I will get comfortable spending some money on the heads later.
  15. GTblack_00

    Turbo cam specs? and where from??

    I am just out for sugg, I was thinking a .050 dur of 220 to 230 intake and exhaust with little or no overlap. I am also going to ask Tim (CK), he has talked to me quite a bit and I should buy something from him. Josh.
  16. GTblack_00

    Turbo cam specs? and where from??

    Sup, What cam specs should I be looking for to complete a turbo setup?? I dont care about Idle quality much, I want it to breath as much as a turbo setup can. This is for a SOHC 5.4 and 2 T3/T4 Hybrid units. THANK YOU!! Josh.
  17. GTblack_00

    Sohc 5.4 Adapter Plates, Where From?

    I have the great 5.4 with some truck intake, I think I want to revert back to my gt intake B4 the turbos get mounted. Anyone know where I can get adapter plates?? Josh.
  18. GTblack_00

    It's tire time for me... need advice!

    www.nittotire.com I have the 555's, turn in is good, dry traction is better than some kdw's I had and playin in the rained out streets around here yesturday was fun with my 555's. (good wet handling.) Better wet handling then my Pirelli P7000's which was rated AA traction(for wet driving)...
  19. GTblack_00

    Just got off the phone with with Diablo Sport...

    If in doubt and you want to do tuning your self TwEEc your car. I am very happy with my Tweecer. The learning curve is a little steep but its fun, I've changed all my timing tables and fuel tables, allowed the computer to instantly switch to OL if there is a defined amount of load but not at...
  20. GTblack_00

    What RPM's with your gears?

    http://locost7.info/mirror/gearbox.php One of the best free gear calcs I have run across. You can enter all gear ratios for tranny 1-6, rear end ratio and tire size. You can also define shift point (type in max power) and max revs, displays all gear revs in speed inc of 5 mph. Josh.
Top Bottom
Back
Forums
Menu