Search results

  1. jammer84_03

    suspension questions for autox/street

    on the track its worth a couple seconds over the kyb's if your pushing it and using them the way they should. for spirited driving, mm has the science down on the suspension and the coil overs. so the decision is yours. i love my konis and mm has the great rep.
  2. jammer84_03

    1991 Mustang Strange noise????

    i've replaced the shocks....still the same noise. changed rear ends....still the noise. the only thing i havent done is the bushings and check for cracks
  3. jammer84_03

    wont start

    well....got it running after lots of tearing back apart and testing. i first scotch brite paded the terminals, second i replaced the neg cable and connector, third i cleaned all the ground points, and last i finally replaced the positive cable and terminal and boom...it fired up without...
  4. jammer84_03

    suspension help

    cant go wrong with mm, there kits are awesome the only thing i would do different is go with the watts link from evolution motorsports instead of the panhard bar....thats whats next on the docket
  5. jammer84_03

    wont start

    now im wondering if its a bad solonoid or starter? could that make the click noice and cause there to be no power in the car?
  6. jammer84_03

    wont start

    checked and rechecked my grounds. now when i reconnect the terminals it will prime the fuel pump again in run, but when i go to start it just kills everything and i have to take the cables off the battery and hook them back up to get power...this is just confusing me.... could this just be a...
  7. jammer84_03

    wont start

    right now i cant even get to the starter clicking. when i first tried to get the car to fire, the starter clicked and the power went out. now i cant even get to that part. i tried the battery in another vehicle i have and it fired right up so im assuming the battery is fine
  8. jammer84_03

    wont start

    i never took those apart is the thing. i just hooked everything back up the way it was after i puller my engine. i read a few posts ago about a guy not having a good ground so i just went and got a new battery to engine ground, cleaned the terminals and i get the door chime and dome light. but...
  9. jammer84_03

    wont start

    just got done checking the battery, and its good. i used it in another car. but i got the wires all hooked up and the dome light wont even come on
  10. jammer84_03

    suspension questions for autox/street

    you will notice a dif with the bils or koni
  11. jammer84_03

    wont start

    hmmm....cuz i got all the ones as normal....i just dont remember seeing the neg ground from the battery going to the block
  12. jammer84_03

    suspension questions for autox/street

    just get the konis or bilsteins to go with it....very easy install...since you already got the mm caster camber places your ready to rock. the next big one is the k-member and the control arms....huge dif there. i got some setup specs for a baseline...pm me for em
  13. jammer84_03

    suspension questions for autox/street

    def go with the coil overs....so many advantages. you can set the corner weights and you get more spring rate compared to a reg coil spring. plus the unsprung weight savings....its a win win all the way around. im going with the mm coilover setup with my koni yellows
  14. jammer84_03

    wont start

    do you ground the neg terminal to the chassis or the block?
  15. jammer84_03

    wont start

    well...just rebuilt the engine and got everything back in. now when i go to start it everything shuts off when i turn the key to the start position. after i turn the key off and let it sir for a few seconds the dome light will come back on and i can turn it back to run and when i go to start...
  16. jammer84_03

    1991 Mustang Strange noise????

    same issue...about to replace bushings and lca's. i believe its the bushings
  17. jammer84_03

    break in period for rebuilt motor

    *seat*....not seal
  18. jammer84_03

    break in period for rebuilt motor

    do NOT run synthetic til at least your 3000 mile change!!!!! or else u can glaze a cylinder or the rings wont seal properly!!!
  19. jammer84_03

    Break in period for new lifters?

    yup...i posted on this subject a week ago....no break in.... let her rock!!!!!!
  20. jammer84_03

    power steering pully company?

    what companys out there offer the power steering pump underdrive pulley. i searched and all i see it power steering issues on cars. i know i've read on here before about a couple places that do the p/s pulley it would be nice so i have more road feel but no turning issue for parking. thx - james
Top Bottom
Back
Forums
Menu