Search results

  1. sn9550

    Header Question

    That's what Stage 8 told me.
  2. sn9550

    1/4 window sealent material?

    I used the same stuff - buytle (sp?). If you use urethane It would be a bear to take out if you ever had to.
  3. sn9550

    Mis-understood ARP head bolt instructions...

    I don't feel so bad now that I know someone else made this mistake.
  4. sn9550

    rack and pinion different on 90 and up than 89 and lower?

    I just put a reman one in my car. There are Ford design and TRW design, sport steering and not. Mine was ford design with the pressure port on the bottm and return above. I think TRW ports are side by side. Plus mine is sport steering. Look and see which one you have. Ford has a little Ford...
  5. sn9550

    Header Question

    If your talking about the Stage 8 then put them on during install. I asked them the same question when I used them the first time. Stage 8 also said there should be no need to retorque.
  6. sn9550

    Mis-understood ARP head bolt instructions...

    I mis-understood the instructions and torqued all the 7/16 head bolts to 85lbsft. I believe they were refering to cast iron with 30wt oil now not aluminum. I know the manual says one torque figure, AFR says 70/80 lbft., and ARP says 60lbft. So do I: a - leave them alone? B - loosen and...
  7. sn9550

    Mis-understood ARp head bolt instructions...

    I mis-understood the instructions and torqued all the 7/16 head bolts to 85lbsft. I believe they were refering to cast iron with 30wt oil now not aluminum. I know the manual says one torque figure, AFR says 70/80 lbft., and ARP says 60lbft. So do I: a - leave them alone? B - loosen and...
  8. sn9550

    AOD shift linkage seal?

    TTT
  9. sn9550

    Where to get a long post starter relay?

    FWIW NAPA does indeed sell a relay/solenoid with longer terminals. They are about an inch compared to half inch stock.
  10. sn9550

    AOD shift linkage seal?

    Anyone relaced the seal on the side of the AOD where the shift linkage connects? If you have what dose it entail? My manual doesn't have anything on it. I knew I should have look at it when I had the trans out.
  11. sn9550

    Got headers! Will I hear/feel the difference? PIC!

    Make sure you check the welds for pin holes. Mine had some that I had to weld up.
  12. sn9550

    Where to get a long post starter relay?

    tmoss thanks, I did the wiring switch as you said but I still might need a longer studded relay or accessory post because I still have my electric fan to hook up. I'll e-mail end of week!
  13. sn9550

    Where to get a long post starter relay?

    Thanks tmoss. I'll be sending you my GT40 lower in about 2 weeks. what's the turn around? starscream88 let me know if you get a measurement! Thanks
  14. sn9550

    Power Steering fluid...best kind?

    Just use type F. Make sure you flush the system good and don't let the level go below the filler tube neck. They don't last long when you start to run them low/empty.
  15. sn9550

    Exact dimensions if SS brake caliper bushings/sleeve?

    Can someone give me the exact dimensions of your stainless caliper bushings i.e length, width, height, i.d., o.d. A drawing would be even better.
  16. sn9550

    Fuel Pressure

    It shouldn't be 60 psi at idle. Pull the vacuum off of it and set it between 36-44psi. For a mostly stock motor don't go any higher.
  17. sn9550

    Where to get a long post starter relay?

    Thanks people. I found a distribution post to use. I want to try and clean up some of the wiring.
  18. sn9550

    AOD w/ non lock-up 2800 stall: where should it be shifting?

    I believe myroc is talking about wot. Did you adjust your TV cable after installing the convertor. The TV cable controls part throttle shift points.
  19. sn9550

    Where to get a long post starter relay?

    Well I just put in my PA Performance starter and had to move the starter positive over. Now I only have the #12 wire, for the solenoid on the load side and every thing else on the line side. Actually I have the starter + going to the battery because there is no more room.
  20. sn9550

    Where to get a long post starter relay?

    I'm looking for a starter relay with longer than stock posts/terminals. Anybody know where to get one?
View older results
Top Bottom
Back
Forums
Menu