Search results

  1. C

    Intake heater hose fitting size

    I'm looking at making up some braided heater hoses for themustang - does anyone know what thread size the intake manifold heater host fitting is? Thanks!
  2. C

    Hydraulic clutch cnc master cylinder

    Or you need to mount the clutch linkage pin closer to the upper pivot to get more leverage
  3. C

    Help Diagnose my Fuel Problem

    I will go for vacuum leak with the possibility of boiling fuel from the carb in addition.
  4. C

    manual to power brake help

    You wont be able to mod the pedal to work with the power booster because you wont be able to get the correct pedal ratio. You should either get the conversion booster, or get the correct booster and a power booster pedal.
  5. C

    Export brace blues

    Check the dimensions compared to another export brace before you spend all that money on chassis alignment
  6. C

    Another edition of the "identify these" game!

    They look very similar to my TW's IIRC.
  7. C

    Tremec 3550 Can't Find shift into 1st and 2nd

    How is your clutch disengagement?
  8. C

    Tuning edlebrock 600

    this might come in handy for some of you guys as well Edelbrock carburetor jetting calculator It lets you calculate the difference between your current jet/rod combo and other possibilities that arent listed on the edelbrock PDF.
  9. C

    Stiff steering after warming up with new control valve assmebly

    I replaced my old control valve assembly a while ago as it was worn out and creating all sorts of issues. The new valve has remedied all of those issues and been working quite nicely except for one thing. When the motor/ps/etc has warmed up completely, the steering gets really stiff at low...
  10. C

    New Photos: March 2009

    Love the colour.
  11. C

    new 408 low dyno numbers

    Order of stuff to fix/check - Throttle linkage - i suspect along with the others youre not getting full throttle opening. - Fuel - needs to go richer - should be closer to 12.5:1 @ WOT instead of 14 - Compression - Spark That carb should easily do 300-400+ hp, probably a heck of a lot...
  12. C

    Noisy Hydraulic Lifters - Any Fix Ideas ?

    Excellent point dhearne. When I built my motor I forgot to check the rear oil gallery and had zero pressure so it could be easy enough to happen at the other end of the engine.
  13. C

    Noisy Hydraulic Lifters - Any Fix Ideas ?

    Mine sounds like that too after a lot of fiddling to try and adjust it out. The proform rockers I had before were much worse than the crane golds I have now.
  14. C

    T5 SnAPS!...again

    Gforce would be easier since you are already setup for a T5. TKO's will need more work around clearances and driveshaft angles etc.
  15. C

    Tremec TKO 600 ???

    Consider yourself lucky - its extremely irritating
  16. C

    CTS-V Calipers, anyone tried to use them?

    Whats the bolt spacing and bolt hole size?
  17. C

    Tremec TKO 600 ???

    Jack did you ever correct your backlash banging? I get the same thing in my tko. I keep wondering if its slack tolerances or just bad design.
  18. C

    "suspension 101" Everything you ever wanted to know about suspension

    Nice. You might want to add a mention for RRS products as theyre a little different to a lot of the stuff youve covered
  19. C

    I'm giving up

    Why not? Do they not work well or do they just look bad?
  20. C

    I'm giving up

    You should go buy a lottery ticket!
Top Bottom
Back
Forums
Menu