Search results

  1. dragnazz5.0

    more RPMS?

    very true...i didnt think about that.
  2. dragnazz5.0

    more RPMS?

    its gonna depend on the heads really. what heads are you running? more than likely if they are stock heads you wont get much more rpm out of the combo but if they are decent heads than you might get a couple hundred more
  3. dragnazz5.0

    Finally got it running, but won't run under load..

    sounds either like a mass air problem or a map sensor problem. unplug the mass air meter and see how it runs. also check to make sure the map sensor is hooked up and getting a good vacuum signal. first check for vacuum leaks at the upper/lower intake, vacuum tree and vacuum ports on the...
  4. dragnazz5.0

    Tubes give more traction?

    are there screws in the rims? there are a lot of things that could cause a tire to loose air. a bad valve stem could do it or the bead could be leaking. mix up some soapy water in a squirt bottle....lay the tire out and spray it down really well and the bubbles will show where its leaking...
  5. dragnazz5.0

    Annoying Noise in Driver Side Front Tire

    it could possibly be the wheel bearings. put the car on jack stands in the front and lift up on the tire and try to wiggle it around. if the wheel bearings are shot you will be able to tell.
  6. dragnazz5.0

    Water Spots from Exhaust

    its just moisture from the exhaust. its actually a good thing. it means the engine is running good. the by products of complete combustion are CO2, and water vapor. i wouldnt worry about it
  7. dragnazz5.0

    NEED HELP BAD

    any particular conditions that this happens in? like it only happens when it rains or when its really hot? pull the codes like jrichker said and we can go from there. if there are no codes than its going to be tough to figure out especially since its an intermittent problem
  8. dragnazz5.0

    Annoying Noise in Driver Side Front Tire

    that ticking noise you hear on the tire could be a nail in the tire? does it get faster with speed? look for a rock or nail in the tire. as for the first noise....what kind of noise is it? rotors rust very often on cars that sit...and its usually just surface rust...which comes off as soon...
  9. dragnazz5.0

    missing and low end power loss

    did you disconnect the battery after you did all this? also, make sure all the vacuum lines are hooked up under the intake and make sure there are no vacuum leaks at the upper to lower intake.
  10. dragnazz5.0

    A whole day and still no start

    are you getting spark? the only thing that i could think of is that the timing chain is either on wrong or the timing is wrong
  11. dragnazz5.0

    Oil Analysis Companies ???

    i used to have a link to a company that sold oil analysis kits. i cant remember the ilnk or how much it was but there are kits out there. they arent cheap but you can use them a bunch of times. might be something to look into if you are serious about doing it a lot
  12. dragnazz5.0

    coil over questions

    alright, im gonna be getting a coil over kit here shortly for the front of my car. im running kyb adjustables right now with stock springs. im not necessarily going for a low ride..just a better ride. im not worried about comfort just handling. basically what im asking is what rate springs...
  13. dragnazz5.0

    Oil Analysis Companies ???

    BITOG is definetly a good site. prepare to put your waders on because some of those guys get deep with their oil knowledge
  14. dragnazz5.0

    2 things i really need help with

    yep...you can take it off since the cats are gone. you might get a code in the computer but it wont make the car run any differently. it will be a secondary air code. dont worry about that. what i did with the back of the heads is take the pipe that goes from one side to the other and cut...
  15. dragnazz5.0

    Can anyone take a measurement for me? (T-5 bolts you pervs!)

    as long as they dont bottom out and as long as they arent help in with 1 thread you should be fine. id try to get a bolt that will thread in atleast 5 threads
  16. dragnazz5.0

    car fell off the blocks

    are those solid aluminum blocks? if so why dont you sell those damn things and get some stang parts. thats a lot of money if they are solid blocks
  17. dragnazz5.0

    2 things i really need help with

    check the link in my sig by tmoss. its got all the vacuum line diagrams you could possibly use. plus some other stuff. as far as the smog pump goes...do you still have cats on the car? if you do i would keep the smog pump since it keeps the cats from clogging due to rich mixtures.
  18. dragnazz5.0

    Gripforce F1 clutch

    that clutch is gonna be an on/off switch. it does have dampening springs to keep it from shocking the driveline too much but its not gonna be a clutch that you can slip for a smooth take off. still looks like a killer deal. id like to know more about it also
  19. dragnazz5.0

    What are these?

    i have never seen anything like that. kind of wierd actually. hopefully someone will chime in with an answer for you.
  20. dragnazz5.0

    custom balance tube ideas

    that does sound interesting. not sure if it would just be overkill but it might work. maybe put two smaller diameter crossovers instead of 1 larger cross over. the only reason ive been thinking about this is because in my class we are tuning nascar engines on an engine dyno and trying...
Top Bottom
Back
Forums
Menu