Search results

  1. 78cobra347

    13.21 video

    THANKS
  2. 78cobra347

    13.21 video

    A better 60' will not help top end speed, u and i know that.But it might help me get the 12.99. The killer head winds that nite held me back,( about 30mph winds) as Greg in the maro runs 106 all the time,he trapped 101. So .05 off the 60' could turn in too .15 at the end. Lex the car is...
  3. 78cobra347

    13.21 video

    81 Camaro with a 350 and 4.10s on slicks
  4. 78cobra347

    13.21 video

    Made 3 runs last nite air was over 5000 feet and really strong head winds. First run 13.6 bad lane choice 2.1 60" 2nd pass [email protected] 2.0 60" 3rd run a [email protected]. 1.93 60' Im sure if i had no wind and my old 1.88 60' times it would land a 12.9? and atleast 105 mph. Right click...
  5. 78cobra347

    Caught a nail in my ET Streets...

    M/Ts are a strange rubber, glue does not stick,but there is a patch that requires no glue it has a rubber nib sticking out. looks like a nice hard nipple on a tit. ckeck around some tire shops they must have some, i have 1 in my Et street right now, its a inside plug kinda thing.
  6. 78cobra347

    help with c4 swap

    Did u find the red wire that loops back into the the plug under the car?That is the wire u have to cut and connect to the tranny park switch. It should start before u cut it in any gear.
  7. 78cobra347

    help with c4 swap

    I just did this on my 89 coupe was not hard. The 4 wires on the tranny are 2 for for neutral safty switch and the other 2 are for reverse lights as for colours i cant remeber but u can figure them out with a ohm meter When in park and neutral 2 will be closed loop and the other 2 will be...
  8. 78cobra347

    Exhaust sound clip links!

    Many good full throttle sound clips. 3" dp and 3" Ultra flow just to the axel no tail pipe. car runs 12.95 so far left click then download http://savefile.com/projects/506888
  9. 78cobra347

    Slow 5 oh going down

    15.4@91
  10. 78cobra347

    Slow 5 oh going down

    just a short vid of my 89 2.3T coupe, not my best run but one that was caught on vid. enjoy http://www.putfile.com/media.php?n=My-2.3-13.6-video&width=320
  11. 78cobra347

    Merkur Turbo PSI

    The stock turbo and stock actuator would only make 9 or 10 psi. If you have the factory boost controller hooked up you get 14 to 15, or go with a aftermarket boost controller and raise it more.
  12. 78cobra347

    What SVO with 22psi could runs on 1/4

    Well maybe, but i would say high 13s to low 14s is more like it.
  13. 78cobra347

    Turbo Upgrade

    What year was the TC? Well a 87 or 88 TC does have a small turbo (ihi). Bigger turbo also has more lag, but will improve power in the higher rpm.
  14. 78cobra347

    I cracked the 13s

    Yea the hardest part to find.
  15. 78cobra347

    I cracked the 13s

    74-78 pinto and mustangII and 79 to 82 or so mustangs.You just need the bell housing and converter/flexplate.Then use a 1970 to 80 C4 from a v8.
  16. 78cobra347

    I cracked the 13s

    Not at all :) I started with a 75 pinto C4. from there my tranny builder who i work with. He had change the 2nd gear Servo as it was too small, he found another that was an E type i think. V8 stuff mostly. The high clutch drum or drive drum was 2 clutches that got swapperd for a C5...
  17. 78cobra347

    I cracked the 13s

    last Fridays best on radials [email protected] and last nite i had the ET streets on ran a 13.6 then a 13.37 and then a [email protected]. 20 lbs and a 50 dry shot in the I/C,the car has a C4 now with a pinto converter. The IHI is long gone, the new T3 .60/.63 with a Buick GN cold side works great. I...
  18. 78cobra347

    26" Rear Drag Tires?

    I had to roll the lip lightly and trim some,very minor though.
  19. 78cobra347

    26" Rear Drag Tires?

    Maybe i can offer some help, i have run a few different 26" slicks. I use a 15x7 weld drag lite 3.5 rear spacing. The goodyear Eagles 26x8x15 has the better fit and 60' time but very shallow holes for wear. In Micky's the ET streets 26x10.5 with side wall, they did rub when the car...
  20. 78cobra347

    Small block cam/intake suggestions?

    Francis u need to give some more info. I think the intakes u got on ur list, have very small intake runners compared the head ports? So will this be auto or stick and what gears do plan to have? How much squeeze is this clevor? I pulled the comp 280h/.512 out of the 66 stang, Les went...
Top Bottom
Back
Forums
Menu