As i can see its ported to the upper lower gasket, or should i say extrude honed? I'm going to port the lower to heads as well just not sure when?Yes i'm adding a 76mm turbo to it also and have a ed curtis cam for that.For now i wanna run N/A with my set us i'm asking about.Then when i pull the...
So a 91 5.0 stock block,AFR 185 58CC heads,1.6 crane gold rollor rockers,4r70w trans,3.55 gears,OEM ported 93 cobra intake,24# or 60# injectors,75mm accufab tb...... so what cam and MAF? peace
john
I had close to the same set up as you except i didnt have the compression as you........I had ported GT40P heads and ported OEM 93 cobra intake and cam and laid out 301/318 to the wheels and had 19's. The dumb ass shop owner here decide to put in 24's and a new MAF for whatever reason,the guy i...
My 351 cost me $4500 for all new everything minus block and internals. Be very very careful of the pistons they are cast and DON'T. like boost.... 94's start roller blocks. 69-74 are the strongest blocks.look by where the starter mounts and the year is stamped there on the block,OR see if there...
I just installed my 3G tonight on my fox.I have a 91 SSP car,and after i installed my 3G and only running it for a few minutes (probably about 10 minutes max)the alt is warm.I ran the orange/black wires to the back of the alt and then ran a 4ga from the back of the alt (same as orange/black...
That will never happen
OH yeah this place is dead for NW section,views yes but posts no. SS still rules.....we just had a meet and a drive till 4 AM friday night on SS,what did stangnet have? peace
john:p
Thanks for your input,but i think you missunderstood me.
Thanks.So are you saying i will need to reset the backlash and so forth once i install extra discs?
Thanks nik :nice: peace
john:p
Going to rebuild the possi in my 8.8.As long as i keep the shims on the correct side when i take it out and then reinstall them in the same spot,i should be ok correct?Also whats the ticket to making the possi tighter?I had my old one done at a shop and if i remember correctly they installed...
I'm asking this cause i'm installing a fast XFI stand alone and they want me to wire a single wire off the fast dizzy to a wire thats hot all the time when the ignition is on as well as when your cranking it.It would be safe to say i could use the Red/green wire? peace
john:p
If i'm reading correctly i want to stay around 160-170 degrees and not go no more then 190 for strip use?I have the controller for the trans also.ANother thing, my cooler is stock (as far as i know) and it also routes threww the radiator..Should i get an aftermarket cooler instead of the stock...