Search results

  1. cobra1923

    Support JennaBears & Why It Was Created.

    I paypal'd a small amount for now, prayers are with you and I applaud what you are doing. You are making the world a better place and proving there are good people out there still.
  2. cobra1923

    Crane HI-6 ignition box....need help deciding

    I just put in a 6000-6440 and can tell you it does have the tach hookup, window switch hookup and I think a timing retard hookup. As well as an adjustable rpm limiter (no pills). I did it b/c I got a really good deal on in but cannot talk to it's realibility or advantages over analog. I...
  3. cobra1923

    Help weird noise car won't start

    Could it be that the battery is just so dead that the little jump pack isn't cutting it? Or a mixture of corroded battery cables and a really dead battery? Do you have another vehicle with a good battery you can swap it out and see if it works.
  4. cobra1923

    manual valve body install questions

    Confused? Are you putting an Auto tranny with manual vlve body in a 5-speed car? I would think that the computer will be fine with the swap but your clutch safety switch will need to be bypassed and you would want to wire in the P/Neutral safety switch on the tranny to the ignition circuit...
  5. cobra1923

    bbk fuel regulator?

    Put the stocker back on and take the BBK and tear it apart. Probably a torn or unseated diaphragm. Kirban and Aeromotive are the schizzle. I am trying a Mallory right now, got too good of a deal to pass it up.
  6. cobra1923

    Engine Missing

    You got a couple of possible sources, maybe spend a couple of bucks and have the injectors cleaned out professionally. If they are the stock 19# with 130K miles, they def need some love. I used to take my fox once a year to a place, they hooked it up at the fuel rail and ran some stuff through...
  7. cobra1923

    Quick question for Vert owners

    Mines has rear def also, but you could get the newer bezel (01-04) I think and they do not have the rear def hole in them, just one hole for the headlight switch.
  8. cobra1923

    To buy or not to buy

    dropping the car is a common and easy mod. It's simply new (shorter) springs, to put it back, all you need is the original spec springs and an alignment. many times the lowering is accompanied with offset or adjustable steering rack bushings, different shocks and caster/camber plates. Those...
  9. cobra1923

    1986 GT with a 93 Upper Intake....

    I guess all those years of adjusting my TPS to below 1.00 on N/A and slightly above 1.00 on my forced induction cars must have been all in my imagination?
  10. cobra1923

    Weird Squeal at high rpms

    Def fan blowing the air The squeal could be a bunch of things, any misc bearing from the accessories, throw out bearing, loose belt? Check your belt to make sure it's not glazed over or chewed up. Then I would yank off your serpentine belt and start spinning pulleys to see if any of them...
  11. cobra1923

    '91 5.0 needs new clutch

    Not sure what your money situation is but you might consider just replacing the cable and adjusting the clutch to see where that leaves you. I've melted a couple of cable jackets and then they will rust and get hard to operate over time. Get a Ford OEM and aftermarket firewall adj and quadrant
  12. cobra1923

    1986 GT with a 93 Upper Intake....

    good point with TPS. Since it was an intake replacement it's either TPS / IAC / EGR or misc vacuum port leak
  13. cobra1923

    1986 GT with a 93 Upper Intake....

    I don't think there is any material difference between the '93 upper and the '86 upper? A '93 from a cobra is a different story and would require the lower also. Idle / jerky etc probably be vacuum related
  14. cobra1923

    "Vert" Rear Window is Intermittent

    had the same issue, take out the 2 screws holding the driver's side switch panel to the actual rocker switches (under the drro handle/ door pull thing).. there are little copper connections that are made when you hit the window switches. I used a small pick and some wd-40 and cleaned all the...
  15. cobra1923

    power window getting stuck???

    I have a drivers side motor if you need, $20 plus shipping and it's yours
  16. cobra1923

    Several Questions, Help Pretty Please

    Most chain auto stores will do for free.. Aotozone, Pep Boys, Advance.. etc
  17. cobra1923

    Cobra 70MM MAF on GT, any issues

    Thanks much guys, glad I checked before I started buying parts.
  18. cobra1923

    Cobra 70MM MAF on GT, any issues

    when you say "tune" I am assuming you're referring to the ECU tune. So then, theoretically, I would need a cobra ECU to run 24# (or an aftermarket MAF or MAF piggyback) and a cobra MAF isn't going to do squat other than be a paperweight.
  19. cobra1923

    Cobra 70MM MAF on GT, any issues

    What size is the stock GT MAF, I thought they were 55MM and the cobras were 70mm?
  20. cobra1923

    Cobra 70MM MAF on GT, any issues

    Can I run a 24# calibrated '95 Cobra 70MM MAF on my 95 GT (with the corresponding 24# squirters?)? without any issues?
Top Bottom
Back
Forums
Menu