Search results

  1. VooDooChild

    Remove "Dogbone" after gear install

    "Dosent take nearly an hr to do a speedo gear swap. My speedo gear is still in mint shape after being put in just about a yr ago." That is true... I personally had bad luck with speedo gears. could not get them to last very long before they were chewed up. But that was some time ago. OT...
  2. VooDooChild

    Remove "Dogbone" after gear install

    I have a 94 Vert and went to 3.73's Dogbone still in, no vibrations. Are you going to be using a SpeedCal to correct your speedo, cause they DO work for our year. And it took an hour in the driveway to put mine in. Well worth the cost vice the speedo gear swap. I did have a sound vibration...
  3. VooDooChild

    Suspension crisis....

    Anyone....... Bueller.... :D
  4. VooDooChild

    Suspension crisis....

    I am looking to finish up my suspension project in the next couple of weeks. So far I have installed: MM full length subframe connectors MM Strut tower brace Have and waiting to install: EBC Sport rotors & Green stuff pads Hotchkis caster camber plates The crisis is springs. I need...
  5. VooDooChild

    H&R Spring Question

    I have been gathering parts for my suspension project on my car. So far I have in the garage still in boxes waiting for install: EBC Sport Rotors & Green Pads Hotckis Caster/Camber Plates Maximum Motorsports strut tower Brace Maximum Motorsports Full length subframe connector Still...
  6. VooDooChild

    What transmission speedo gear do I need.

    Just get a SpeedCal. I have 3.73's and the SpeedCal. I got mine at DallasMustang. It took about an hour to install and it was well worth it. You can make adjustments for just about any gear and tire combo. And it will be exact. I have checked it with my GPS. I have a 94 Cobra so I know it...
  7. VooDooChild

    MASS Air Adjuster

    ttt
  8. VooDooChild

    MASS Air Adjuster

    Does anybody know the correct procedure to adjust this thing? Are you supposed to get it as close to 1.0 as you can? I have no documentation with it. It is installed on a 86LX with a Paxton sn2000, 24lb injectors and a 65mm TB. I have attempted to adjust it both with the just the...
  9. VooDooChild

    Uncle Meat

    I was there from 81-about 85 and from 90-91. I bet we know each other.
  10. VooDooChild

    Uncle Meat

    Marine One, You with 2nd AAVBN??
  11. VooDooChild

    Cat-less gas mileage

    Well don't take this the wrong way, but maybe if you think about it you will figure it out. When you installed an off road pipe your driving habits will change. You will find yourself winding it out more often, and generally driving it harder because of the sound. I may be wrong, but I have...
  12. VooDooChild

    Tweecer/Speedcal Question??

    They do work on ours.... Installed it 2 weeks ago. I have a speedcal on mine. I installed 3.73's and decided to use the speedcal instead of changing the tranny gear.
  13. VooDooChild

    Speed Cal?

    Does the SpeedCal work for 94's?? I saw on the Brothers site $84.99 but the page is confusing. It says: Brother Speedcal All 1994-2003 Mustangs (5-speed only) below it says a must for all gear swaps on 1999-2002 Mustangs and farther down the page it says: Can also use on 94-98...
  14. VooDooChild

    4.30:1 gear/AOD/ speedo gear?

    Where do you get the 23 tooth gears at?
  15. VooDooChild

    1993 Cobra gears

    I just installed 3.73's about a month or so ago... and you will see a big difference down low. Its not too bad on the highway, unless you like to run 90+ I don't have that much luck to run that fast on the highway... but you will have traction problems in 1st and 2nd on street tires. Hammering...
  16. VooDooChild

    3.73's are in, one problem

    Had new clutch packs in mine... hence the 50x50 break-in... If it was just gears, like Joe said, if its set up right then no problems with hammering it right off the lift.
  17. VooDooChild

    3.73's are in, one problem

    Yes no faster than 50 mph for 50 miles. Dude that was taken care of.... :)
  18. VooDooChild

    Need help choosing tires.

    rim lip protector Swingline... I am running Falken GR-B FK-451 255/40ZR17's They have the lip protector. Pretty good tires IMO.
  19. VooDooChild

    3.73's are in, one problem

    :D :D Just got done with my 3.73 install about 4 hours ago.... man you are right, NO TRACTION at all. Love it. I know that the cold weather had alot to do with the traction. Heated them up then launched. There was a difference with warm tires but I am running 255's and they can't hold...
  20. VooDooChild

    '95 5.0 300 RWHP?? How too?

    I hear ya 95snoozer.... Drop tops are FAT ladies..... But we love em... :D :banana:
Top Bottom
Back
Forums
Menu