Search results

  1. S

    Hissing sound around the intake?

    Why would it only occur when the engine warms up though? Take off the upper intake? I still think the gasket is less than a year or two old... but okay.
  2. S

    Hissing sound around the intake?

    I haven't visually seen any steam and the water temp has not gone beyond 190, but I will look at those lines.
  3. S

    Hissing sound around the intake?

    I just started having an issue with a hissing sound. It doesn't occur on cold start up, but when the water temp hits around 180+ I will hear the hissing noise. I've checked the radiator, reserve, and oil. The car is driving fine. I've tried to look for a vacuum leak but not felt anything...
  4. S

    Photos of my car

    Buddy shot these at work... still don't quite see how nice the pearl is
  5. S

    Exhaust

    I went with an x-pipe with 2 1/2 inch pipes and flowmaster exhaust, sounds good and breathes well
  6. S

    LA Area: Need Help installing new leaf springs

    taken care of, please delete thread
  7. S

    Remote Starter Solenoid Wiring Question

    Never mind that terminal in the back left is not a ground, its to be used if I need to jump the car in the event I can't get into it. (Shaved door handles and poppers)
  8. S

    Remote Starter Solenoid Wiring Question

    What you're seeing is a lot of the wiring for the amplifiers. I need to clean it up badly And yes he did run a ground from the stud -_-
  9. S

    Remote Starter Solenoid Wiring Question

    I'm going to remove the ground and just wire it like the diagram... can't believe this is as messed up as it is.
  10. S

    Remote Starter Solenoid Wiring Question

    He said the reason he grounded it was because the Solenoid sits on top of lizard skin and he was concerned that wasn't enough
  11. S

    Met the girl of my dreams today

    Are there Cliff notes on this thread?
  12. S

    Remote Starter Solenoid Wiring Question

    I have a remote starter solenoid and battery where the back seat would be in my car. When my dad wired it he setup a ground for the Solenoid. He also didn't run the 12 gauge wire or the other part of the mini-starter. I burnt up the starter last weekend because it stayed engaged and now I...
  13. S

    Starter Stays Engaged (my wiring is a mess, help me fix it)

    Okay I do have that ground in the trunk, should the solenoid be connected to that ground? Yes or no
  14. S

    Starter Stays Engaged (my wiring is a mess, help me fix it)

    Sounds right, I think I have it figured out, I just need to wait till Saturday to do it though... So Antsy to fix it. It turns out that my dad did run a ground from the solenoid for some strange reason.
  15. S

    Mustang Sagging Driverside Rear

    I found a shop called Marlo's Frame & Alignment in Chatworth that has been used in a lot of the Mustang magazines... If the frame is bent in the rear and it requires repair... is there the possibility of my paint cracking or other issues that come with frame repair? I'm really upset that I...
  16. S

    Starter Stays Engaged (my wiring is a mess, help me fix it)

    I don't have a single wire starter though, I have one of the mini starters. I probably could benefit from using the multimeter though... I look at those other wiring diagrams and see one side of the solenoid has all the hot stuff going into the one side... and on mine I have something going...
  17. S

    Starter Stays Engaged (my wiring is a mess, help me fix it)

    Was that the wiring diagram you were talking about btw?
  18. S

    Starter Stays Engaged (my wiring is a mess, help me fix it)

    Can you explain the isolated feed through?
  19. S

    Starter Stays Engaged (my wiring is a mess, help me fix it)

    Thanks for the reply, I figured I really needed that 2nd wire... but looking at my Solenoid I still don't know which part to hook it up too
  20. S

    Starter Stays Engaged (my wiring is a mess, help me fix it)

    On the far left you can see that terminal that I think might be a ground... no idea. My dad did most of the wiring
Top Bottom
Back
Forums
Menu