Search results

  1. SaltWaterFish

    emblem measurement

    I think there are some that have switched to the pony for the v6 look, but for the most part we can't help you.
  2. SaltWaterFish

    rocker arms.....? long...

    My car developed a loud ticking noise under the #4 cylinder after rodding around last weekend. It was bad enough that I took it to a shop to have them look at it. They said to fix the problem they would have to install a kit that basically consisted of longer push rods for $150 plus 2-3 hours...
  3. SaltWaterFish

    What wax do you guys use?

    Zymol!! Smells good and lasts longer then Meguiars.
  4. SaltWaterFish

    O/T:You must read this thread

    Check this out! Read all the posts. http://forums.stangnet.com/showthread.php?t=454566
  5. SaltWaterFish

    COBRA MASTER CYLINDER

    Sounds like there is still air in the lines. Did you bleed the air out of the master cylinder before you put it on? Did you have someone helping you or did you use a bleeder kit? You can't do it right by yourself without a kit. Did you start with the back right side and work your way...
  6. SaltWaterFish

    need help loss my tourqh

    Did you double check your timing? Did you set the timing with the number one cylinder? You may have used the 5 cylinder by mistake. Are you still running with the stock heads? If you are you need to switch to the Trickflow street heat intake. The R is a short runner high RPM intake that lacks...
  7. SaltWaterFish

    HELP...car making a squeaking noise when rolling backwards. HELP

    Have you checked your u-joints? Jack your rearend up and with the car out of gear spin each tire backwards. This can help you find which side it is coming from.
  8. SaltWaterFish

    Help!! Went to start car....

    Take your belt off and try to turn all the pulleys. You should be able to turn them without much effort. I agree with Andy, smog pump.
  9. SaltWaterFish

    Problem with FMS Racing sparkplugs...

    If you bought the kit brand new it will come with two extra wires. The one in the pic is for old style coils. The other is a regular plug wire with a number on it. I think #5 or #3. It will snap onto the coil if you press hard enough. If you decide to sale them b/c they are to long get some...
  10. SaltWaterFish

    fuel regulator?

    Thanks for your input Andy and you are right. I put my stock regulator back in and with the engine cold and the vac line on it put out 32#. Without vac it jumped right to 40#. I'm guessing if I let the car warm up the idle will drop and give me a lower reading with the vac line on. So my...
  11. SaltWaterFish

    fuel regulator?

    Here is a pic of the gauge. Don't mind the dirty engine.
  12. SaltWaterFish

    fuel regulator?

    The p/n for the gauge is SUM-800160 and you'll need an adapter fitting p/n ATM-3280. I think I've got a bad regulator. With the vac unhooked I can set it right at 38#. When I hook up the vac it drops to 28-29#. It will spike up to 32-34# when I rev up the motor. I have not tried to adjust...
  13. SaltWaterFish

    fuel regulator?

    I installed a Kirban regulator and a Summit fuel gauge today and need to know if you set the pressure with the vacume line on or off? Is 38psi a good start?
  14. SaltWaterFish

    Please help with stupid thermostat

    To see if your stat is working properly boil some water on the stove. When the water starts boiling remove the pot and with a pair of pliers dip the stat in the water. It should open all the way. If it does not it is no good! If this checks out then I would start calling around for the...
  15. SaltWaterFish

    Installed UPR shifter!

    Mine was just black silicone and I used putty knife and my finger nail to get it off.
  16. SaltWaterFish

    Installed UPR shifter!

    The only problem I had was getting the first rubber boot out. I had to put a screwdriver in the holes of the metal ring to pry it loose. Get some RTV and something to take off the old gasket. Need a 13mm and 5/16 sockets. The stock shifter will look flimsy compaired to the one your putting...
  17. SaltWaterFish

    Installed UPR shifter!

    Picked up a used UPR shifter and knob from a guy at work for $100. :nice: Put it in today and all I can say is I should have done it years ago! :banana: This is a great mod!
  18. SaltWaterFish

    WRECKED mystic

    You could swap the whole interior if you wanted to. They are the same. Sorry to hear about your friends car. There is a Mystic here in town that looks sweet! I wish they made them in 95, rather have the 5.0 then the 4.6.
  19. SaltWaterFish

    Fuel pressure Gauge

    I just ordered a summit fuel guage and it should be here today. I also ordered a NOS "T" fitting. I'm going to use the T fitting so I can keep the shrader valve to let the air out of the line when I change fuel filters. I'll post some pics when I get done.
  20. SaltWaterFish

    PCV PIC

    Here is a shot of the back side of the intake. The arrow points to the location. The PVC slides inside the rubber gromet. It is hard to see and you almost have to lay on top of the engine.
Top Bottom
Back
Forums
Menu