Search results

  1. S

    Magnacharger Install....

    How long did it take to install with the intercooler and how is the throttle responce compared to the stock tune?
  2. S

    Dyno results Underdrive pulleys

    No timing adjustment needed. Dyno's have been from around 5-10hp and around 10lbs of tourqe if you google it and hunt for a while. I noticed a differance when I had Steeda's installed about 6 months ago. MM & FF's most recent magazine comes with a DVD on a 05 GT piece by piece install and...
  3. S

    15 inch Rim

    MM & FF did and article one or two months back and they had to modify the front swaybar with some aftermarket part to fit a 15" rim. They were running 12.5 with just bolt ons. As far as the shot, 150 is pushing the "safe" envelope, but if you have it tuned properly you can run it. I ran a 150...
  4. S

    Steeda crank pulley, oil leak???

    I went back to the shop and they fixed it. They said they put enough silicon on that it would take an impact wrench to get it off. No more leak :)
  5. S

    Best Cold Intake and Programmer?

    I made a clear plastic shield, but the way the intake cone sits, I have to bend the material. Plexiglass can't bend the way I need it too...Wish it could, believe me, I've tried a bunch of different ideas, but I can't make it look show quality.:bang:
  6. S

    Best Cold Intake and Programmer?

    I thik C&L is the best mainly because of the heat shield. I bought a Tunable Induction one which looks sweet and makes about the same power on the dyno compared to the C&L, but the heat shield doesn't seal up to the hood and I get a lot of hot air. I made a custom top part to shield it from...
  7. S

    American Thunder exhaust

    http://www.andersonfordmotorsport.com/media/exhshoot1.htm here's the data...
  8. S

    Steeda crank pulley, oil leak???

    Thanks guys! I had a shop install it so I'll be heading back to them armed with info :)
  9. S

    07 exhaust

    I have Flowmasters and they don't drone much...just around 1500rpm up a hill and on the freeway around 75-80mph, but I have 4:10s out back...
  10. S

    Steeda crank pulley, oil leak???

    So I looked under my hood today and there was oil on my Steeda crank pulley in the center area. It was lightly sprayed around the spot I saw(most likely from it spinning off the pulley). Anyone have experiance with this? Is it serious? Thanks in advance.
  11. S

    American Thunder exhaust

    I have it. It sounds great, just louder than stock and not "different" like some of the open exhausts out for our stang. As far as fuel economy, don't expect anything different, but Anderson Ford did a nice online dyno test of exhausts vs stock and the performance is better in some rpm ranges...
  12. S

    gears and the automatic

    I have 4.10's in my auto and love them. I drive 65-70mph and it's fine. Only lost about 1/2 mpg. Pick up is great.
  13. S

    Cold Air Intake Time!

    Some cold ait intakes don't require a tune, but they do not offer as much power as one with a tune. Your looking at 15-20 without a tune and 25-30 with one. You could have someone from a performance shop flash your computer, but you need to store your stock tune somewhere and therefore you...
  14. S

    Flowmaster Axle Back

    I am running it with no other exhaust mods. Sounds good. Not too much louder, but growls much better now. A bit of drone but not much. Only at certain rpms...Mainly up hill around 1500rpm
  15. S

    ? for those of you using NOS

    I have used Zex kit for years with no problems on an SVT focus, but have yet to install it in my 05 GT...and as for the true question... http://www.cnlperformance.com/inlet.html That's C&L's tube with a spot already ready for NOS. Not free, but I'd say it's better to be safe with NOS and not...
  16. S

    Loss in hp / torque from mufflers?

    http://www.andersonfordmotorsport.com/media/exhshoot1.htm
  17. S

    ? about octane and brenspeed

    I have the Demolet Tunable Induction intake and tune. When I ordered it from Demolet, I told him that we only have 92 octane here in Washinton. He said that I could run the 93 octane tune and would probably be fine. He said to just listen for any detonation and change the tune if needed.
  18. S

    Exhaust Question?

    Full exhaust would cost around $2000 installed and net around 15-20hp. The axle back are producing around 7hp max when a striaght through design. Check out Anderson Ford on Google. They have the 3 shootouts written up in MM&FF. They don't have the long tube exhaust setup, but it will give...
  19. S

    I've decided on Borla....

    Steeda's exhaust is made by Borla. Same deal with the FRRP Stinger exhaust...
  20. S

    brenspeed tunes

    I have 4.10's and at 70mph it's about 2700rpm. Not sure what the 1st gear is topping out at though, never paid attention. I'll tell you later tonight :)
Top Bottom
Back
Forums
Menu