Search results

  1. pudman

    this is just wrong

    came across this today MUSTANG LX
  2. pudman

    Upper Diff Bushing Install Question

    IIRC the bushings have a slight taper to them. when they stop going in that's it. when I did mine on my '86 one side did go in farther than the other. And that was how the stock ones were also
  3. pudman

    kill switch and 3g alt

    black and orange wires are not used with a 3g upgrade. just tape them off. as far as the kill switch there are many options on what to kill
  4. pudman

    MSD 6A #2 died. suggestions for others

    it's mounted between the air filter box, and strut tower
  5. pudman

    MSD 6A #2 died. suggestions for others

    well my second MSD 6A just died, and I want to replace it with something else. I hear the Crane stuff is much more reliable, but there are so many different kinds. so I'm looking for some suggestions to replace the 6A with a comperable unit. This is going on a totally stock 86 GT daily driver...
  6. pudman

    ignition switch bad??

    update upon further investigation it turns out to be the MSD box. I didn't even think of it at the time. This will be the second one gone bad. I'll remember your suggestions for the next time :nice:
  7. pudman

    ignition switch bad??

    86 gt mustang. so I'm sitting at a red light, and the car just died. tried restarting with no luck. fuel pump primes; engine cranks strong, but no go. I did the no spark no fuel test and concluded it is getting no spark. when I did the following test.... Place ignition key in on, with the...
  8. pudman

    tire height help!

    i would say they will be way too tall. I ran 255/60/15 on my 86 with 5" backspace and they hit on even the slightest cornering. I'm running 265/50/15 now,but needed a 1/4" spacer
  9. pudman

    MSD 6al?

    my car definitely feels stronger and throttle response is better on my stock 86 5.0 HO. it will also help a bunch for emissions. my stock 86 with 372,000+ original miles still passes calif test only smog!!
  10. pudman

    Convertible Leak? Water on Floor

    jshell55...sent you a PM :nice:
  11. pudman

    Convertible Leak? Water on Floor

    the oval shaped hole just in front of the rear tire on my 86 is the drain hole. this is getting very interesting now. here's a pic of my deal the white square is where the water comes in from the trough system...except that black piece needed to be pushed closer to the guide post the oval...
  12. pudman

    Where to mount my MSD Box!!?!?

    here's mine on my '86 vert. pretty much the same as Repostyle[/IMG]
  13. pudman

    Convertible Leak? Water on Floor

    I had the same problem on my '86 vert. There is a drain hole in the floor straight down below the window regulator. Mine was plugged up with leaves and junk.
  14. pudman

    Simple spring question???

    guess I'm too late. I've got "C" springs on my '86 vert. Dead coil cut from the rears, and 1/2 coil cut from front. Drives like a tank on rails. Ran over a dime and felt it.:rlaugh::rlaugh:
  15. pudman

    Taillight Tint on gt?

    i'm sure that would be the best method, but the paint is a quick, cheap and very effective way of doing it
  16. pudman

    Taillight Tint on gt?

    +1 on the chrome paint. Did this to my '86 GT with outstanding results!! Just taking the lenses off and washing the inside makes a big difference
  17. pudman

    New and need help with gauges on 5.0

    if the IVR was bad I would think there would be an effect on all that it controls. The IVR drops 12 volt power down to 5 volts which is what the gauges need. If you take one of your gauges out and hook it up to a 9 volt battery the needle will peg
  18. pudman

    New and need help with gauges on 5.0

    are the other gauges working properly? if not i would say the IVR is bad. if it's just the gas gauge... could be the gauge itself or the sending unit. as for the speedo...sounds like the wrong speedo gear. have the rear end gears been changed? 20 mph is alot to be off. sounds like you're...
  19. pudman

    dash lights wont turn on. PLEASE HELP!

    I really don't think it's the bulbs. Chances of all going out at the same time is not likely. Maybe the switch is bad. The dimmer mechanism might be dirty or just faulty
  20. pudman

    electric oil pressure gage

    thanks for the response. it's been hooked up since Saturday, and so far I've noticed no difference in battery power. But I think I will do it right. One more problem I have is the dimming of the light. The gage does the opposite of the instrument cluster. Full instrument light... no gage. Full...
Top Bottom
Back
Forums
Menu