Just fixed it!!!! All I did was clean the ground cables, warm up the engine, clear the codes, and all i got was 22 and 95!!! I had about 5 other codes before!!!!
Just fixed teh 41 and 91!!!! All I did was clean one of the ground cables, warmed up the engine, cleared the codes and all I got was 22 and 95!!! 22 is expected but will 95 do anything to smog??
Ive pulled codes
95 O: Fuel pump secondary circuit fault
41 C: HEGO (HO2S) sensor signal out of range/ always lean...No HO2S switching detected
91 C: HEGO (HO2S) sensor signal out of range/ always lean
What are my chances of passing smog??
Is there a difference between codes 41 and 91?? I am getting both. I thought the problem was that they wern't grounded but I grounded them and Im still getting these codes. I looked at the O2 sensors from the outside and pulled one out and they look pretty good. The sensor part had a little film...
i coded my pony and I got an 02 sensor problem. I think it was a grounded wire so I grounded it and I coded it again and it came up again. Do I have to drive the car for a little bit for the codes to clear or do I still have a problem?
I pulled code 91 and I am trying to figure out the problem. I just installed a new engine and had everything disassembled. I just folowed the wires that came out of the O2 sensors and found an orange wire went to this little box that is suppose to be mounted to the left side of the engine...
My smog pump is ticking pretty loudly. Kinda annoying. I am getting is smogged soon so I want to make sure it will pass. Is there any way to grease the inside of the smog pump or anyone know why it is making noise??
I just put a new engine in with a new water pump but kept the old radiator. I was having massive overheating problems before but it was because I had a chunk missing out of my heads. I got the car started today but when I drove it the engine temp seemd to keep moving around from the middle to...
I spun the tires and I was pretty exact and it came out to be 3.5 which I am assuming is 3.55 gears. If my drive and driven gears are stock, should I expect a 30% increase in my speedometer??
I got it running!!! Thanks guys!!
The problem was that since my ignition is f'ed up I was starting it from the sylinoid but I wasnt getting any electricity in the engine. All I was doing was runing the starter. I had to have the igniition turned on so I got that electricity and it fired right...
when ever i try to top dead center it and adjust the distributor, I start it up, it cranks but doesnt turn over. Then I top dead center it again and check the distributor and the rotor is always like 180 degrees away from spark plug 1.